Abstract:The proposed radio‐frequency receiver is a low‐IF receiver architecture, not a zero‐IF Rx, with the IF frequency being twice the channel bandwidth, that is, the intermediate frequency in the RF receiver equals 200 MHz. The radio‐frequency receiver consists of a low‐noise driver stage (RF stage) and an in‐phase/quadrature of phase (I/Q) demodulator. The low‐noise driver stage is designed using a complementary current‐reuse common‐gate configuration with shunt feedback to achieve wideband RF input matching with ultra‐low power dissipation, enhancing linearity compared to the conventional configuration. Summary This paper presents a battery‐free ultra‐low‐power (ULP), highly integrated, and wide‐bandwidth low‐IF radio‐frequency (RF) receiver designed for millimeter‐wave (mm‐Wave) applications, utilizing 130‐nm CMOS technology. The suggested RF receiver is suitable for K‐band (n258) at 26 GHz, Ka‐band (n261 and n257) at 28 GHz, and the LMDS band at 28 GHz in fifth‐generation applications. The proposed radio receiver consists of a low‐noise driver stage implemented using a complementary current‐reuse common gate with an active shunt feedback configuration and an in‐phase/quadrature‐phase (I/Q) demodulator. The proposed RF receiver employs transformer coupling to isolate the DC path between the transconductance stage (RF stage) and the switching stage (IF stage). The driver stage expands the RF input impedance while maintaining acceptable linearity and gain with ultra‐low DC power dissipation. The DC supplies for the proposed mm‐Wave RF receiver are generated using two novel energy‐harvesting voltage doubler circuits to provide positive and negative voltages. The proposed mm‐Wave radio receiver consumes 0.475 mW from a 1.1 V DC supply and exhibits a power conversion gain (CG) of 6.3 dB, with a 3 dB frequency bandwidth extending from 22 to 32 GHz. The input 1‐dB compression point (P1dB) of the RF receiver is −2.65 dBm, and the input third‐order intercept point (IIP3) is 7.35 dBm. With a sensitivity of −66.5 dBm at a 100 MHz channel bandwidth and a dynamic range of 63.85 dB, the suggested receiver demonstrates notable performance characteristics. The proposed radio receiver boasts an excellent figure of merit (FoM) at 215 dB, surpassing published works by a margin of 8–31 dB. The primary positive supply voltage is derived from a double‐band positive voltage doubler with series resonance feedback and parallel resonance networks, efficiently achieving the desired DC voltage and output current (1.1 V and 450 μA). Meanwhile, the negative gate bias is provided by a negative voltage doubler, ensuring the necessary negative voltage (−0.5 V) without any current conditions.

Ultra-low power, high-data rate, fully on-chip radio frequency on-off keying receiver for internet-of-things applications

Low power high data rate GHz range receiver in 40nm CMOS technology

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

20 . 6 A 0 . 6 V 32 . 5 mW Highly Integrated Receiver for 2 . 4 GHz ISM-Band Applications

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

Ultra low-power transceiver with novel FSK modulation technique and efficient FSK-to-ASK demodulation

A 780-MHz low power transceiver for wireless nodes applications in Internet of Things

An Energy Efficient Fully Integrated OOK Transceiver SoC for Wireless Body Area Networks

A power efficient 60 GHz 90nm CMOS OOK receiver with an on-chip antenna

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

Towards Ultra-Low Power OFDMA Downlink Demodulation.

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

Battery‐free ultra‐low‐power radio‐frequency receiver for mm‐wave applications using 130‐nm CMOS technology with harvested DC supplies

A 60-Ghz OOK Receiver with an On-Chip Antenna in 90 Nm CMOS.

A 197.1-μW Wireless Sensor SoC With an Energy-Efficient Analog Front-End and a Harmonic Injection-Locked OOK TX

A Low-Power and Flexible Energy Detection IR-UWB Receiver for RFID and Wireless Sensor Networks

A Low Power Impedance Transparent Receiver with Linearity Enhancement Technique for IoT Applications.