28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS
Jinbo Li,Zhiwei Xu,Qun J. Gu
DOI: https://doi.org/10.1109/ISSCC.2019.8662474
2019-01-01
Abstract:The increase of carrier frequency enables the utilization of the abundant highfrequency resource to meet the ceaseless demand for high data-rates. With respect to the transmitter, the design challenges include linear and high-efficiency PAs at high frequencies, low out-of-band (OOB) noise for frequency division duplex (FDD) applications, etc. Moreover, the integration of PAs on the CMOS die with other transmitter blocks greatly reduces the form factor and cuts down the cost. Among various linearization techniques, the Cartesian feedback architecture excels in its robustness against the process, voltage and temperature (PVT) variations as well as aging effects, but suffers from the noise-linearity trade-off caused by the feedback path [1-3]. To mitigate this issue, a Cartesian errorfeedback architecture is proposed by adopting a reference path to cancel the signal before the feedback path and only leave the error information in principle. In this work, an X-band Cartesian error-feedback transmitter with a fully integrated power amplifier in bulk CMOS is implemented, and delivers maximum power (P
<sub>SAT</sub>
) of 21.4dBm and output-referred 1dB compression point (OP
<sub>1dB</sub>
) of 21dBm. At PSAT and OP1dB, the PA efficiency reaches 33.3% and 30.3%, with total system efficiency of 22.3% and 20.3%, respectively. Compared with the open-loop condition, the closed-loop transmitter demonstrates up to 13.6dB suppression of ACLR using WCDMA uplink (UL) signals, and improves EVM by over 6dB for 4Ms/s 64-QAM signals and over 3dB up to 16Ms/s signals. The out-of-band noise at 100MHz is -133/-131.8dBm/Hz for the lower and upper sidebands respectively.