Abstract:This article presents a 17.720.2 GHz eight-element four-beam RF-beamforming transmitter in 65-nm CMOS for satellite communication (SATCOM). The transmitter utilizes an analog scheme in the variable-gain amplifier (VGA) to achieve dB-in-linear gain control with a high dynamic range (DR), together with a current combining crossbar for a compact footprint. The vector-modulation-based (VM-based) phase shifter (PS) adopts the cancellation-based $G_\mathrm{m}$ units for low switching variation. Furthermore, eight PSs of each beam are split into two groups, with each group sharing the same tunable I/Q generator for low power consumption. Considering the increased peak-to-average power ratio (PAPR) caused by high-order modulation schemes and multibeam operation, the transmitter incorporates compact transformer-based Doherty power amplifiers (DPAs) with adaptive bias control to improve the power efficiency at back-off. The chip achieves a 31-dB gain-tuning range with a 0.283-dB step and a 360 $^{\circ}$ phase-shifting range with a calibrated 7-bit resolution. The measured root-mean-square (RMS) phase/gain errors induced by the VGA/PS are below 2.05 $^{\circ}$ /0.147 dB, respectively, which decouples phase/gain control. The transmitter achieves a maximum output 1-dB gain compression point (OP $_{\mathrm{1 dB}}$ ) of 17.9 dBm and a maximum saturated power ( $P_{\mathrm{sat}}$ ) of 18.9 dBm. The output element exhibits 29.3% drain efficiency (DE) at 6-dB power back off (PBO) from $P_{\mathrm{sat}}$ , which is 1.56/3.12 times over the normalized class-B/class-A implementations, demonstrating Doherty PBO efficiency enhancement. The chip occupies an area of 8.59 $\times$ 4.17 mm $^2$ and consumes 398 mW per element at OP $_{\mathrm{1~dB}}$ . Additionally, a 16-element linear array has been developed to showcase the capabilities of the multibeam operation and gain tapering.

A Single-Ended Digital Transmitter Based on I/Q-Sharing Switched-Capacitor Power Amplifier and Third-Order Harmonic-Rejection

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A $K$-Band Four-Beam Transmitter with Decoupled Phase/Gain Control and Enhanced Power Back off Efficiency for SATCOM

The Design of All-Digital Polar Transmitter Based on ADPLL and Phase Synchronized ΔΣ Modulator

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

A Hybrid Digital Transmitter Architecture for High- Efficiency and High-Speed Applications

A 9.4 Pj/bit 432 MHz 16-QAM/MSK Transmitter Based on Edge-Combining Power Amplifier

A Fully-Integrated Wideband Digital Polar Transmitter with 11-Bit Digital-to-Phase Converter in 40nm CMOS.

4.4 A Highly-Integrated 6-Phase Cell-Reused Digital Transmitter Using 1/3 Duty-Cycle LO Signals for Harmonic Rejection.

A Fully Integrated QPSK/16-QAM D-Band CMOS Transceiver With Mixed-Signal Baseband Circuitry Realizing Digital Interfaces

A Fully Integrated Digital Polar Transmitter with Single-Ended Doherty PA and DLL-Based Three-Segment Hybrid DTC in 28 Nm CMOS

24.5 A 15b Quadrature Digital Power Amplifier with Transformer-Based Complex-Domain Power-Efficiency Enhancement.

A Wideband Digital Polar Transmitter with Integrated Capacitor-DAC-Based Constant-Envelope Digital-to-Phase Converter

A 0.1&#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS

An All-Digital Quadrature RF Transmitter with 8-Bit ΣΔ Modulation

A 5-Ghz Quadrature Switched-Capacitor Power Amplifier with IQ-Cell-Sharing and Serial Transformer Combiner in 28-Nm CMOS

A Transformer-Based Quadrature Doherty Digital Power Amplifier With 4.1 W Peak Power in 28 nm Bulk CMOS

A 4.1 W Quadrature Doherty Digital Power Amplifier with 33.6% Peak PAE in 28nm Bulk CMOS.