Abstract:The increase of carrier frequency enables the utilization of the abundant high-frequency resource to meet the ceaseless demand for high data-rates. With respect to the transmitter, the design challenges include linear and high-efficiency PAs at high frequencies, low out-of-band (OOB) noise for frequency division duplex (FDD) applications, etc. Moreover, the integration of PAs on the CMOS die with other transmitter blocks greatly reduces the form factor and cuts down the cost. Among various linearization techniques, the Cartesian feedback architecture excels in its robustness against the process, voltage and temperature (PVT) variations as well as aging effects, but suffers from the noise-linearity trade-off caused by the feedback path [1]–[3]. To mitigate this issue, a Cartesian error-feedback architecture is proposed by adopting a reference path to cancel the signal before the feedback path and only leave the error information in principle. In this work, an $X -$band Cartesian error-feedback transmitter with a fully integrated power amplifier in bulk CMOS is implemented, and delivers maximum power $( \mathrm {P}_{SAT})$of 21.4dBm and output-referred 1dB compression point (OP $_{1dB})$of 21dBm. At $\mathrm {P}_{SAT}$and OP $_{1dB}$, the PA efficiency reaches 33.3% and 30.3%, with total system efficiency of 22.3% and 20.3%, respectively. Compared with the open-loop condition, the closed-loop transmitter demonstrates up to 13.6dB suppression of ACLR using WCDMA uplink (UL) signals, and improves EVM by over 6dB for 4Ms/s 64-QAM signals and over 3dB up to 16Ms/s signals. The out-of-band noise at 100MHz is -133/-131.8dBm/Hz for the lower and upper sidebands respectively.

A 0.1&#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 0.1-5.0 GHz SDR Transmitter with Current-Mode Power-Mixer and Self-Calibration Scheme in 65 Nm CMOS

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A 0.13µm CMOS 1.5-to-2.15ghz Low Power Transmitter Front-End for SDR Applications

A 0.7-8 GHz High IF Frequency-Extended Transmitter Front-End with −47.1-Db EVM at 16 QAM in 65-Nm CMOS

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 0.1–6.0-Ghz Dual-Path SDR Transmitter Supporting Intraband Carrier Aggregation in 65-Nm CMOS

A 1.2V 0.1&#x2013;3ghz Software-Defined Radio Receiver Front-End in 130nm CMOS

A 0.1–5.0 GHz Reconfigurable Transmitter With Dual-Mode Power Amplifier and Digitally-Assisted Self-Calibration for Private Network Communications

A 0.1–1.5G SDR Transmitter with Two-Stage Harmonic Rejection Power Mixer in 65-Nm CMOS

A 0.1–5ghz Flexible SDR Receiver in 65nm CMOS

A 0.1–4 GHz SDR receiver with reconfigurable 10–100 MHz signal bandwidth in 65 nm CMOS

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A 0.1–5.0 GHz Flexible SDR Receiver with Digitally Assisted Calibration in 65 Nm CMOS

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

An integrated 60GHz 5Gb/s QPSK transmitter with on-chip T/R switch and fully-differential PLL frequency synthesizer in 65nm CMOS

A 0.07–3 GHz Wideband Front-End for SDR Receiver with 2.3 Db NF and 12 Dbm IIP<sub>3</sub> in 65 Nm CMOS

A 0.1–1.5GHz dual-mode Class-AB/Class-F power amplifier in 65nm CMOS

A 0.1&amp;#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS