Abstract:Stainless steels are increasingly used in construction today, especially in harsh environments, in which steel corrosion commonly occurs. Cold-formed stainless steel structures are currently increasing in popularity because of its efficiency in load-bearing capacity and its appealing architectural appearance. Cold-rolling and press-braking are the cold-working processes used in the forming of stainless steel sections. Press braking can produce large cross-sections from thin to thick-walled sections compared to cold-rolling. Cold-forming in press-braked sections significantly affect member behaviour and joints; therefore, they have attained great attention from many researchers to initiate investigations on those effects. This paper examines the behaviour of residual stress distribution of stainless steel press-braked sections by implementing three-dimensional finite element (3D-FE) technique. The study proposed a full finite element procedure to predict the residual stresses starting from coiling-uncoiling to press-braking. This work considered material anisotropy to examine its effect on the residual stress distribution. The technique adopted was compared with different finite element techniques in the literature. This study also provided a parametric study for three corner radius-to-thickness ratios looking at the through-thickness residual stress distribution of four stainless steels (i.e., ferritic, austenitic, duplex, lean duplex) in which have their own chemical composition. In conclusion, the comparison showed that the adopted technique provides a detailed prediction of residual stress distribution. The influence of geometrical aspects is more pronounced than the material properties. Neglecting the material anisotropy shows higher shifting in the neutral axis. The parametric study showed that all stainless steel types have the same stress through-thickness distribution. Moreover, R/t ratios' effect is insignificant in all transverse residual stress distributions, but a slight change to R/t ratios can affect the longitudinal residual stress distribution.

Simulation analysis of stress distribution of high-strength steel in cold roll forming

Fine analysis of section stress of steel strand

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Analysis of stress-strain in the partial heating roll forming process of high strength square hollow steel sections

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

Research on the Mechanism and Processability of Roll Forming

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Forming limit of hot-rolled high-strength steels considering sheet thickness effect

An investigation on longitudinal residual strains distribution of thin-walled press-braked cold formed steel sections using 3D FEM technique

Careful finite element simulations of cold rolling with accurate through-thickness resolution and prediction of residual stress

Research on Holding Pressure and Cooling Process During Hot Forming of Ultra-High Strength Steel 22MnB5

FINITE ELEMENT ANALYSIS OF STEADY STATE HV ROLLING PROCESS OF SLAB

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Finite Element Analysis on the Local Buckling Behavior of High Strength Steel Members under Axial Compression

Quenching Stress of Hot-Rolled Seamless Steel Tubes under Different Cooling Intensities Based on Simulation

Rolling Process Analysis of Working Rollers of Cold Rolling Mill Based on ANSYS

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

Numerical Prediction of Residual Stresses Distribution in Thin-Walled Press-Braked Stainless Steel Sections