Abstract:The modeling of the asymmetric cold rolling process of steel strip is carried out using the Deform program. During the study, the diameter of the barrel of the upper work roll is varied from 570 to 600 mm, the diameter of the barrel of the lower work roll was left unchanged at 600 mm, and changes in the structural parameters of the deformation zone, as well as the required rolling torques and forces, are recorded. The results are obtained for the conditions of rolling strips made of low-carbon steels with a thickness of 2 mm or more, as well as 0.35...0.5 mm. It is found that the discrepancy in power between the drives of the upper and lower rolls during asymmetric rolling can reach 25 % of the power required to conduct the process on rolls with the same barrel diameter. It is also shown that the changing of the contact arc with the indicated changes in power and a decrease in the diameter of the working roll barrel from 600 to 570 mm ranges from 3 to 5 % of the length of the arc of contact in the absence of a difference in the diameters of the barrels of the rolls. Fluctuation in moments when taking into account the factor of asymmetric rolling reaches 20 % of the corresponding values typical for the technological process on rolls with the same barrel diameter. An increase in the asymmetry of the rolling process leads to a slope of the neutral section in the deformation zone with an increase in the proportion of the advance zone in the arc of contact of the upper work roll with a smaller diameter of the barrel and the strip. An assumption is made, which requires further research, about the possibility of creating only one advance section along the entire length of the interaction of the roll with a smaller diameter of the barrel and the strip. Such a structure of the contact zone is theoretically able to reduce the required power of the main drive.

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Influence of rolling force optimization on thickness accuracy of 20-high cold-rolling mill of silicon steel

The central strain analytical modeling and analysis for the plate rolling process

Numerical simulation of cold longitudinal asymmetric rolling process

Analysis of flatness and critical crown of hot-rolled strip based on thermal-mechanical coupled residual stress analytical model

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Prediction and analysis of rolling process temperature field for silicon steel in tandem cold rolling

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Static softening behavior of 316L stainless steel under flexible rolling process

Rolling Process Analysis of Working Rollers of Cold Rolling Mill Based on ANSYS

Mathematical modeling and simulated analysis of metal flow behavior during the FGC of ESP rolling process

Vacuum Hot Rolling Preparation of a Stainless Steel Clad Plate and Its Numerical Simulation

Effects of operation parameters of cold rolling on surface finish of aluminum

Numerical Simulation of Oxide Scales Evolution During Hot Strip Rolling

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process