Numerical simulation of cold longitudinal asymmetric rolling process

A.V. Kozhevnikov,D.L. Shalaevsky,Yu.V. Platonov,A.S. Smirnov,K.P. Korepina,I.A. Kozhevnikova

DOI: https://doi.org/10.36652/1684-1107-2023-21-6-271-277

2023-01-01

Abstract:The modeling of the asymmetric cold rolling process of steel strip is carried out using the Deform program. During the study, the diameter of the barrel of the upper work roll is varied from 570 to 600 mm, the diameter of the barrel of the lower work roll was left unchanged at 600 mm, and changes in the structural parameters of the deformation zone, as well as the required rolling torques and forces, are recorded. The results are obtained for the conditions of rolling strips made of low-carbon steels with a thickness of 2 mm or more, as well as 0.35...0.5 mm. It is found that the discrepancy in power between the drives of the upper and lower rolls during asymmetric rolling can reach 25 % of the power required to conduct the process on rolls with the same barrel diameter. It is also shown that the changing of the contact arc with the indicated changes in power and a decrease in the diameter of the working roll barrel from 600 to 570 mm ranges from 3 to 5 % of the length of the arc of contact in the absence of a difference in the diameters of the barrels of the rolls. Fluctuation in moments when taking into account the factor of asymmetric rolling reaches 20 % of the corresponding values typical for the technological process on rolls with the same barrel diameter. An increase in the asymmetry of the rolling process leads to a slope of the neutral section in the deformation zone with an increase in the proportion of the advance zone in the arc of contact of the upper work roll with a smaller diameter of the barrel and the strip. An assumption is made, which requires further research, about the possibility of creating only one advance section along the entire length of the interaction of the roll with a smaller diameter of the barrel and the strip. Such a structure of the contact zone is theoretically able to reduce the required power of the main drive.