Abstract:This paper presents the results of physical modelling of the process of multi-pass rolling of a wire rod with controlled, multi-stage cooling. The main goal of this study was to verify the possibility of using a torsion plastometer, which allows conducting tests on multi-sequence torsion, tensile, compression and in the so-called complex strain state to physically replicate the actual technological process. The advantage of the research methodology proposed in this paper in relation to work published so far, is its ability to replicate the entire deformation cycle while precisely preserving the temperature of the deformed material during individual stages of the reproduced technological process and its ability to quickly and accurately determine selected mechanical properties during a static tensile test. Changes in the most important parameters of the process (strain, strain rate, temperature, and yield stress) were analyzed for each variant. After physical modelling, the material was subjected to metallographic and hardness tests. Then, on the basis of mathematical models and using measurements of the average grain size, chemical composition, and hardness, the yield strength, ultimate tensile strength, and plasticity reserve were determined. The scope of the tests also included determining selected mechanical properties during a static tensile test. The obtained results were verified by comparing to results obtained under industrial conditions. The best variant was a variant consisting of physically replicating the rolling process in a bar rolling mill as multi-sequence non-free torsion; the rolling process in an NTM block (no twist mill) as non-free continuous torsion, with the total strain equal to the actual strain occurring at this stage of the technological process; and the rolling process in an RSM block (reducing and sizing mill) as tension, while maintaining the total strain value in this block. The differences between the most important mechanical parameters determined during a static tensile test of a wire rod under industrial conditions and the material after physical modelling were 1.5% for yield strength, approximately 6.1% for ultimate tensile strength, and approximately 4.1% for the relative reduction of the area in the fracture and plasticity reserve.

Modelling of the Rolling Process of Titanium Alloy Tube Billets in Laboratory Conditions on a RSP 14-40 Rolling Mill

DEVELOPMENT OF THE TECHNOLOGICAL PROCESS OF ROLLING BARS IN THE NEW DESIGN RADIAL SHEAR MILL BY USING PHYSICAL MODELING

Experimental testing of a new helical rolling technology

Innovative Methodology for Physical Modelling of Multi-Pass Wire Rod Rolling with the Use of a Variable Strain Scheme

Improvement of tool calibration in cold pilligrim rolling mill

Computer-aided and experimental study of temperature effect on the quality indicators of piercing mandrels when rolling steel 50 vessels on a screw-rolling mill 30–80. part 1

Computer-Simulation Assessment of the Stress–Strain and Kinematic States of a Titanium Nickelide Billet during Screw Rolling

Numerical simulation of cold longitudinal asymmetric rolling process

Short-Flow Rolling Process and Heat Treatment of Seamless Titanium Alloy Tube

An Experimental Study of the Thermal State of a Steel Billet during Hot Rolling

Texture evolution and controlling of high-strength titanium alloy tube in cold pilgering for properties tailoring

Modeling of cold pilgering of stainless-steel tubes

Providing the necessary type of metal microstructure of titanium and zirconium pipes.

Numerical and experimental analysis of the isothermal high temperature pneumoforming process

Study on the Influence of Mandrel Speed on the Titanium Tube Continuous Retained-Mandrel Rolling Process

Study of mandrel wear during billet piercing on the MISiS-130D screw rolling mill

A study of conditions of surface defects formation when bar rolling at a bar and wire mill and methods of their elimination

Influence of Cold-Rolling Processes on the Dimensional Accuracy and Roughness of Small-Diameter Thick-Walled Seamless Tubes

Study of CNC skew rolling of hollow rail axles with a mandrel

Optimization of Mechanical Properties during Cold Rolling and Wrap-Forming for Metal Helical Tubes

Material Science Aspects of Titanium Tube Production. Part 2. Production of Cold-Rolled Tubes