Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Investigation of the Influence of Deep Rolling on the Thermal Fatigue Cracking for Aisi H13 Steel

Analysis of the Influence of Contact Stress on the Fatigue of AD180 High-Carbon Semi-Steel Roll

Analysis of thermal-mechanical coupling strength and fatigue life of cylinder head

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

Numerical simulation of continuous hot rolling process for ultra-thick SiCp/2009Al composites plate

Effect of warm surface rolling on fatigue property of H13 steel

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

Research on the Temperature and Thermal Stress of the Roll Quenching Process of Thin Plates

Finite Element Analysis of Contact Stresses on the Backup Roll of CVC Hot Rolling Mills

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Novel analytical heat source model for cold rolling based on an energy method and unified yield criterion

Investigation of oxide scale on ferritic stainless steel B445J1M and its tribological effect in hot rolling

Numerical Simulations of Friction Stir Welding Process and Subsequent Post Weld Cold Rolling Process

Numerical Simulation of Multi-Pass Hot Rolling of TA1/Q235B Clad Plates

Evolution of Surface Crack on Slab During Rough Rolling Using Thermal-Mechanical FEM

Numerical Simulation and Mechanism Analysis of Thermal Fatigue Crack for Low-Alloy Steel Brake Disc of High-Speed Train

Careful finite element simulations of cold rolling with accurate through-thickness resolution and prediction of residual stress