Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

Evolution of Surface Crack on Slab During Rough Rolling Using Thermal-Mechanical FEM

The Cracks on Slab Corner During Hot Rolling Process

Effect of Rolling Process Parameters on Transverse Cracks on the Surface of Q345 Steel

The Causes and Control of Longitudinal Edge Cracks of the Plate

Cracking in a Fe–25Mn–3Si–3Al Steel

Establishment of Thermal Ductile Fracture Criterion for As-Cast 42CrMo Steel and Its Application in Hot Ring Rolling Process

Study on Surface Longitudinal Crack Formation of Typical Hypoeutectoid Steel Produced on a Caster with Billet and Slab

Hot Cracking of Low Alloy Steels in Simulated Continuous Casting-Direct Rolling Process

Surface rolling FE model for numerical simulation

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Subsurface propagation of partial ring cracks under rolling contactPart II. Fracture mechanics analysis

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

FINITE ELEMENT ANALYSIS OF STEADY STATE HV ROLLING PROCESS OF SLAB

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Understanding Microstructure-Evolution-dependent Fracture Behaviors in Pearlitic Steels

Rolling contact fatigue failure mechanism of bearing steel on different surface roughness levels under heavy load

The effect of friction on surface crack initiation in rolling contact fatigue considering damage accumulation

Thermal cracking: clarifying the effects of phases, voids and grains through characterisation and crystal plasticity modelling

Subsurface propagation of partial ring cracks under rolling contact: Part I. Experimental studies

On the effect of microplasticity on crack initiation from subsurface defects in rolling contact fatigue

Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders