Abstract:Abstract Central cracking in cross-wedge-rolled workpieces results in high wastage and economic loss. Recent cross-wedge rolling tests on two batches of steel showed that one batch formed central cracks, while the other was crack-free. The batches were both nominally of the same chemical composition and thermomechanical treatment history. In addition, both batches had passed all the standard quality assessments set for conventional forging processes. It was suspected that the different cracking behaviours were due to differences in microstructure between the two as-received steel billets, and the material in cross-wedge rolling (CWR) was more sensitive to the initial microstructure compared with other forging processes due to its specific loading condition including ostensibly compression and large plastic strain. Nevertheless, no previous study of this important problem could be identified. The aim of this study is, therefore, to identify the key microstructural features determining the central crack formation behaviour in CWR. The hot workability of the as-received billets was studied under uniaxial tensile conditions using a Gleeble 3800 test machine. Scanning electron microscope with energy-dispersive X-ray spectroscopy and electron backscatter diffraction was applied to characterise, quantitatively analyse, and compare the chemical composition, phase, grain, and inclusions in these two billets, both at room temperature and also at the CWR temperature (1080 °C). Non-metallic inclusions (oxides, sulphides, and silicates) in the billets were determined to be the main cause of the reported central cracking problem. The ductility of the steels at both room and elevated temperatures deteriorated markedly in the presence of the large volumes of inclusions. Grain boundary embrittlement occurred at the CWR temperature due to the aggregation of inclusions along the grain boundaries. It is suggested that a standard on specifying the inclusion quantity and size in CWR billets be established to produce crack-free products.

Study on Surface Longitudinal Crack Formation of Typical Hypoeutectoid Steel Produced on a Caster with Billet and Slab

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

The Causes and Control of Longitudinal Edge Cracks of the Plate

Analysis of the Formation Mechanism of Surface Cracks of Continuous Casting Slabs Caused by Mold Wear

Analysis and control of surface cracks in a B-bearing continuous casting blooms

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Factors Effecting Surface Quality of Hypo-Peritectic Steel Slab Cast at High Speed

Prediction and Analysis on Formation of Internal Cracks in Continuously Cast Slabs by Mathematical Models.

Cracking in a Fe–25Mn–3Si–3Al Steel

Formation and control of the surface defect in hypo-peritectic steel during continuous casting: A review

Evolution of Surface Crack on Slab During Rough Rolling Using Thermal-Mechanical FEM

Analysis of Internal Cracks in Continuous Casting Slabs with Soft Reduction

Propagation form of internal cracks induced by continuous casting soft reduction and control strategy for internal quality

Numerical Simulation of Central Shrinkage Crack Formation in a 234-T Steel Ingot

Influence of Mineralogical Structure of Mold Flux Film on Heat Transfer in Mold during Continuous Casting of Peritectic Steel

A Method to Control the Transverse Corner Cracks on a Continuous Casting Slab by Combining Microstructure Analysis with Numerical Simulation of the Slab Temperature Field

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Review of Formation Condition for Internal Crack in Continuous Casting Slab

Formation mechanism and control of a kind of pit-shaped defect in Cf53 rolled products