Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Mechanism and Influencing Factors of Overvoltage on Inverter-Fed Traction Motor Terminal

Study on Voltage Distribution in Windings of an Inverter-Fed Traction Motor

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Research on Mechanism of Bearing Voltage in Metro Vehicle Traction System

Risk Assessment of Post-Fault Temporary Overvoltage Using Generalized Short-Circuit Ratio

Modeling and Experimental Analysis of Overvoltage and Inrush Current Characteristics of the Electric Rail Traction Power Supply System

Study on Neutral-Bus Overvoltage Mechanism of ±500 Kv DC Power Transmission Project from Tianshengqiao to Guangdong

The Impact Analysis of Operational Overvoltage on Traction Transformers for High-Speed Trains Based on the Improved Capacitor Network Methodology

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

Analysis Of Voltage Waveform At The Stator Terminal Of Pwm Inverter Fed Motors

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Influence of Cable Insulation Structure on Terminal Over-Voltage of Inverter-Fed Motor

Electrical damage mechanism analysis of traction motor bearings on high-speed trains considering overvoltage impulse

On the DC Transient Overvoltage in the Converter Stations of ±800 Kv Xiluodu Zhexi HVDC Project

Study on the Over-Voltage and Over-Current of Grid-Connected Inverters in Non-Fault Conditions

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project

Calculation of Transient Voltage Distribution in Windings of Inverter-fed Traction Motor

Research on Overvoltage Characteristics and Influencing Factors of Converter Station under Grounding Fault

Propagation Characteristics and Influence Mechanism of Vacuum Circuit Breaker Switching Overvoltage on High-speed Electric Multiple Unit

DC switching overvoltage of ± 1100 kV UHVDC converter station

Modeling and Overvoltage Suppression Analysis of Grid-connected Converter with VSG Control Strategy under Commutation Failure