Abstract:The technical and economic efficiency of electric rolling stock (ERS) is determined by the characteristics of its traction electric drives, the key ones of them being the manufacturing cost, repair and maintenance costs, service life, specific energy consumption, and operational reliability. The modern ERS uses induction electric drives with pulse-width control of the voltage and frequency control of the rotation frequency. The field experience gained from operation of electric drives equipped with semiconductor converters has shown a growing number of cases involving accelerated wear of the traction machine bearings. Currents through the bearings or shaft currents, which usually flow from the electrical machine shaft through the bearings, have been known since the time the electrical machines were invented. Owing to recent achievements made in power electronics, the application field of inductor motors has become much wider. In particular, the use of inverters with pulse-width modulation (PWM) and high switching frequency make it possible to operate an electric drive with a lower acoustic noise and with more efficient energy conversion; however, the use of inverters also entails the generation of bearing currents in induction motors. The article analyzes possible factors causing the occurrence of bearing currents. Typical changes occurring in the bearings as a result of electric current flowing through them are shown: the rolling surface becomes dull, grooves on the ball race occur, and lubrication becomes degraded. The influence of operating parameters on the frequency of the occurring breakdowns and the distribution of forces in the bearing system depending on the load are considered. A conclusion is drawn that the potential problem of bearing currents should be solved using design, structural, and algorithmic methods at different stages of design and operation of electrical systems involving adjustable electric drives.

Research on Mechanism of Bearing Voltage in Metro Vehicle Traction System

Stability improvement control for metro traction drive system

Research on Traction and Levitation Characteristics of High-Speed Maglev Train Based on BP Neural Network

An Overview of Bearing Voltages and Currents in Rail Transportation Traction Motors

Electrical damage mechanism analysis of traction motor bearings on high-speed trains considering overvoltage impulse

Implementation and Experiment Verification of a Metro Power Traction Simulator System

Performance and Control Method of PMSMs Traction System in High Speed Train under Passing Neutral Section Condition

Study on the DC-Side Oscillation Mechanism Analysis and Suppression Strategy for Metro Traction Drive System

A Control Scheme for a High Speed Railway Traction System Based on High Power PMSM

Modeling and Simulation of Metro Bilateral Power Supply System

Mechanism and Influencing Factors of Overvoltage on Inverter-Fed Traction Motor Terminal

Research on Load Unbalance Problem and Control Strategy of Traction Motors in High-speed Train

Simulation and Analysis Method for the Operation Characteristics of CIT400 High-Speed Comprehensive Inspection Train Based on Predictive Current Control

Dynamic Analysis of Support System of Permanent Magnet Traction Motors for High-Speed Trains

An Analysis of Damages Inflicted to the Bearing of Rolling Stock Traction Machines Powered by Frequency and Voltage Converters

The Influence of the Motor Traction Vibration on Fatigue Life of the Bogie Frame of the Metro Vehicle

Study on Voltage Distribution in Windings of an Inverter-Fed Traction Motor

Avoid Bogie Bearing Failure of IGBT Inverter Fed EMUs and Locomotives

Modeling and Simulation of the 1500V Metro Supply Network and Vehicles

Influence Of Dc-Link Voltage Fluctuation On The Performance Of Railway Traction Drive With Different Low Switching Frequency Modulation Techniques

Hybrid Energy Storage System of Metro and Its Control Methodon Power Dynamic Allocation