Abstract:The non-uniform corrosion of steel bars is the main factor affecting the durability of concrete. The cracking pattern of concrete due to corrosion is closely related to the distribution of the corrosion products. Research on the thickness distribution of the rust layer and the cracking pattern of concrete under different influencing factors is of great significance in the prediction of the service life of existing reinforced concrete structures and the avoidance of the premature cracking of the reinforced concrete structures to be built. This paper studies the thickness distribution of the rust layer on the surface of single and multiple corroded reinforcements under non-uniform corrosion. The electrochemical analysis of the electrified corrosion process was carried out by using the finite element analysis software, and the distribution of the current density was obtained. The effects of geometric parameters, steel bar position, and steel bar spacing and shape on the corrosion expansion cracking pattern were studied. The results indicated that as the position of the steel bar differed, the crack pattern of the concrete changed, depending on the number of corrosion peaks (i.e., the maximum thickness of the rust layer). In terms of the corner-located steel, the number of corrosion peaks varied in the cases of different geometrical parameters (i.e., the diameter of the steel bar and the distance between the steel bars and the stainless steel wire). Nevertheless, the critical corrosion degrees of the side-located and corner-located steel bars, with respect to the cracking of the outer concrete surface, were basically the same. Additionally, the ribbed steel bar presented a lower critical corrosion degree than that of the plain steel bar, while little influence was exhibited with the varying angles of the rib.

Study on Experimental Method and Morphology of Accelerated Non-Uniform Corrosion of Steel Bars

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Study of Wiring Method on Accelerated Corrosion of Steel Bars in Concrete

Fractal Characterization of Non-Uniform Corrosion of Steel Bars in Concrete Beams after Accelerated Depassivation and Seven-Year Natural Corrosion.

Mechanical Performance of Corroded Steel Bars in Concrete

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

Non-uniform Corrosion of Steel in Mortar Induced by Impressed Current Method: an Experimental and Numerical Investigation

Rust Distribution of Non-Uniform Steel Corrosion Induced by Impressed Current Method

Modelling the corrosion mechanism of steel bars in chloride-contaminated concrete with transverse cracks

A Comparison Study on the Natural and Half-Soaking Galvanic Accelerated Corrosion of Reinforced Concrete Based on an Improved Electrochemical Model

Study on Corrosion Mechanism of Steel Bars in Concrete and Mechanical Performance of Corroded Steel Bars

Experimental Study of the Modulus of Steel Corrosion in a Concrete Port

Experimental investigation of composite steel-concrete beams with corroded studs

Study On Distribution Of Steel Corrosion Products In Concrete Structures

EXPERIMENTAL STUDY OF PIEZOMAGNETISM OF PITTING CORROSIONSTEEL BARS UNDER TENSILE FORCE

Numerical Simulation of Steel Corrosion in Chloride Contaminated Concrete

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Experimental Investigation of the Bond Performance Between Nonuniformly Corroded Reinforcing Bar and Concrete

Stochastic Characteristics of Reinforcement Corrosion in Concrete Beams under Sustained Loads

Non-Uniform Distribution of A Corrosion Layer at A Steel/Concrete Interface Described by A Gaussian Model