Abstract:Non-uniform corrosion of steel reinforcing bars is the main cause of structural failure in civil engineering. However, the accurate measurement of the critically corroded cross-sectional area, or the pit shape, is difficult owing to conventional limitations on detection. To accurately represent the corrosion morphology and better understand the corrosion effects on the tensile responses of deformed steel bars, a three-dimensional model of a corroded steel bar was reconstructed using a three-dimensional (3D) laser scanner. Based on the elicited 3D profiles, the corrosion factors-including the corrosion uniformity-the average, and maximum cross-sectional areas and their relationships, were identified in this study. The statistical analyses indicated that the number of corroded pits and their depths increased when the corrosion rate increased, and that decreases of the critical cross-sectional areas were linearly related to the average mass loss. Axial tensile tests of corroded steel bars were also carried out. The tensile test results showed that both the yield and the ultimate loads linearly decreased with increases in corrosion loss. Corresponding decreases in ductility were also observed. Compared with the degradation in the strength, the non-uniform corrosion had a considerable effect on the loss of ductility. The relationships between the mechanical parameters and the corrosion factors were established on the basis of the experimental results, and compared with the available prediction models. It was found that fractures originated at the locations of the critically corroded pit, and brittle fracture gradually occurred at the weakest location of the corroded steel bar, evidenced by concomitant increases in corrosion loss. Numerical simulations were carried out to clarify the critical section, the effect of pit corrosion on the concentration of stress, and the tensile response of the corroded steel bar, based on the 3D model reconstructed using scanning.

Improved Magnetic-Based Apparatus Enables Non-Destructive and High Sensitive Steel-Bar Corrosion Detection

Numerical Simulation of a Magnetic Corrosion Detector for Corrosion Detection of Steel Rebar in Concrete

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Experimental study on stress detection of corroded steel bars based on piezomagnetic effect

Experimental research on fatigue properties of corroded steel bars based on dynamic piezomagnetism

Study on Experimental Method and Morphology of Accelerated Non-Uniform Corrosion of Steel Bars

EXPERIMENTAL STUDY OF PIEZOMAGNETISM OF PITTING CORROSIONSTEEL BARS UNDER TENSILE FORCE

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Modelling the corrosion mechanism of steel bars in chloride-contaminated concrete with transverse cracks

Mechanical Performance of Corroded Steel Bars in Concrete

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Evaluation of Nonuniform Corrosion of Steel in Concrete Based on Two-Yoke Magnetic Sensor

Study of Wiring Method on Accelerated Corrosion of Steel Bars in Concrete

Corrosion Mechanism of Reinforced Bars Inside Concrete and Relevant Monitoring or Detection Apparatus: A Review

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

A Self-Balanced Electrochemical Model for Corrosion of Reinforcing Steel Bar in Considering the Micro-Environments in Concrete

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

Steel Bar Corrosion Monitoring Based on Encapsulated Piezoelectric Sensors

Corrosion Monitoring of Reinforcing Steel in Concrete by Electrochemical Sensors

Rebar Corrosion Detection in Concrete Based on Capacitance Principle

Evaluation of Corrosion Characteristics and Corrosion Effects on the Mechanical Properties of Reinforcing Steel Bars Based on Three-Dimensional Scanning