Abstract:Abstract Electrochemical deposition of CoCu/Cu multilayers was performed on titanium substrates from a single bath as a function of the Cu layer thicknesses. The deposition potentials were selected as −1.5 V for the magnetic layers and −0.3 V for the non-magnetic layers with respect to the saturated calomel electrode. The current-time transients were obtained during the deposition process, and the Co layer deposition and capacitive transients were calculated. On the basis of structural analysis, the multilayers were found to be polycrystalline with both Co and Cu layers adopting the face-centered cubic structure. The calculated lattice parameters of the multilayers slightly increase from 0.3585 to 0.3615 nm with increase in the Cu layer thickness, which is consistent with the bulk value of Cu. The inter-planar distance of the peaks of the multilayers is closer to that of Cu ( d 111 =0.2087 nm) and Co ( d 111 =0.2046 nm), and they become close to that of bulk Cu with increasing Cu layer thickness. In magnetic measurements, the magnetization decreases from 156 to 44 emu/cm 3 depending on the Cu layer thickness. Furthermore, the coercivity of the multilayers increases from 20 to 140 Oe. These values show that the magnetic behaviour of the multilayers lie between those of soft and hard magnetic materials, but the multilayer having 2.5 nm Cu layer thickness shows hard magnetic property. For the CoCu(4 nm)/Cu(0.7 nm) multilayer, the magnetoresistance measurement shows 5.5 % giant magnetoresistance (GMR).

Electrical Performance and Adhesion Strength of Magnetron Sputtered Cu/Ag Double-Layer Films

Optical and Wetting Properties of CuAlO2 Films Prepared by Radio Frequency Magnetron Sputtering

Adhesion improvement of sputtered Cu films on flexible polymer substrates through the design of metal interlayers

Effects of technological parameters in magnetron sputtering process on properties of metallized films

Metallization of SMD Inductor of Ferrite Ceramics by Magnetron Sputtering

Dielectric properties of the silver–copper alloy films deposited by magnetron sputtering

Effect of High-Frequency and High-Density Current on Adhesive Strength of Copper Thin Film

Influence of high-frequency discharged-aided magnetron sputtering deposition and argon pressure on structure and magnetic properties of Co/Cu multilayer film

Microstructure evolution and anti-wear mechanism of Cu film fabricated by magnetron sputtering deposition

Preparation of Ag-Cu nanoparticle film using a dual-beam pulsed laser deposition for power electronic packaging

Evaluation of the Electromagnetic Characteristics on Ag/NiCuZn Ferrite Sintered Bodies

Effect of deposition parameter on properties of AlSn20Cu coating prepared by magnetron sputtering

Magnetic And Electric Properties Of Fe3o4 Thin Films Sputtered On Metallic Underlayer

Adhesion Strength and Tribological Properties of Cr/Ag Nanoscaled Multilayer Films

Sintering Mechanism of a Supersaturated Ag-Cu Nanoalloy Film for Power Electronic Packaging

Plasma surface pretreatment to improve interfacial adhesion strengths of sputtered Cu on polyimide film

Supersaturated Ag-Cu nanoalloy film for high reliability power electronic packaging

Interlayer Design for Strong Adhesion in the Double-Layer Flexible Copper Clad Laminate Via Hipims Deposition

Electrochemical Deposition of CoCu/Cu Multilayers: Structural and Magnetic Properties as a Function of Non-magnetic Layer Thickness

Interfacial Bonding Mechanisms of Sintered Cu Nanoparticles on Different Metallization Surfaces

Achieving High Strength and High Electrical Conductivity in Ag/Cu Multilayers