Abstract:Mordenite composite membranes were prepared by means of coating a porous α-alumina support with nanosized mordenite seeds followed by hydrothermal crystallization. A systematic investigation was performed on the influence of several factors such as ageing of the reaction mixture, alkalinity, salt addition and temperature on the formation of a mordenite membrane on the seeded support. The ageing of the reaction mixture reduces the growth rate of mordenite crystal along a-axis and b-axis but hardly influences the growth rate along c-axis. As a result, the boundaries between the surface crystals become a little larger with prolonging the period of ageing time. The growth rate of the mordenite crystal along individual axes increases first and then decreases with increasing concentration of sodium hydroxide. A higher alkalinity is unfavorable for the formation of a continuous mordenite membrane. The addition of salt in the reaction mixture has different effect on the growth rate of the mordenite crystal along each axis. With increasing the amount of salt, there was hardly influence on the growth rate along c-axis, whereas an obvious decline was observed in the growth rate along either a-axis or b-axis, which enlarges the boundaries between the surface crystals. The growth rate of the mordenite crystal increases more along c-axis than that along a-axis or b-axis with increasing temperature for hydrothermal crystallization. The use of a temperature as high as 473 K produces a membrane composed of bar-like crystals with larger boundaries.

Discussion on mechanism of preparing mullite composite nanocrystallines

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Preparation of Mordenite Composite Membranes with Seeding

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion

The Interaction of Cellulose and Montmorillonite in a Hydrothermal Process

Fabrication of Composite Coating Particles with Mullite Stoichiometric Ratio by a Novel Processing

Mullite formation from reaction sintering of ZrSiO4/α-Al2O3 mixtures

Preparation of Magnesium Hydroxide Chloride Hydrate Nanowires Using Calcined Dolomite

Preparation and properties of Al2O3/Al-2(1-0.2)Mg0.2Ti(1+0.2)O5 matrix ceramic composite

Fabrication of Fine Mullite Powders by Heterogeneous Nucleation and Growth Processing

Fabrication of Mullite Powders by A Novel Processing

Preparation and Characterization of Mullite Whiskers from Different Silica Sources via Molten Salt Reaction

Reaction mechanisms and properties of in situ porous Al2O3-ZrO2-mullite composites

Preparation and properties of porous mullite-based ceramics fabricated by solid state reaction

Study on comprehensive properties of mullite porous ceramics prepared from gangue based on sintering temperature

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Preparation of Mullite Monoliths with Well-Defined Macropores and Mesostructured Skeletons Via the Sol–gel Process Accompanied by Phase Separation

Thermal decomposition and reaction sintering for synthesis of mullite-zirconia composite using kaolin, γ-alumina and zirconia

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Reaction sintering of ZrSiO4/α-Al2O3 mixed powders with Y2O3 addition

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method