Abstract:Theoretical or numerical progressive collapse analysis is necessary for important civil structures in case of unforeseen accidents. However, currently, most analytical research is carried out under the assumption of material elasticity for problem simplification, leading to the deviation of analysis results from actual situations. On this account, a progressive collapse analysis procedure for truss structures is proposed, based on the assumption of elastoplastic materials. A plastic importance coefficient was defined to express the importance of truss members in the entire system. The plastic deformations of members were involved in the construction of local and global stiffness matrices. The conceptual removal of a member was adopted, and the impact of the member loss on the truss system was quantified by bearing capacity coefficients, which were subsequently used to calculate the plastic importance coefficients. The member failure occurred when its bearing capacity arrived at the ultimate value, instead of the elastic limit. The extra bearing capacity was embodied by additional virtual loads. The progressive collapse analysis was performed by iterations until the truss became a geometrically unstable system. After that, the critical progressive collapse path inside the truss system was found according to the failure sequence of the members. Lastly, the proposed method was verified against both analytical and experimental truss structures. The critical progressive collapse path of the experimental truss was found by the failure sequence of damaged members. The experimental observation agreed well with the corresponding analytical scenario, proving the method feasibility.

A New Protection Criterion Against Plastic Collapse

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

LOAD AND RESISTANCE FACTOR DESIGN OF DUAL CRITERION AGAINST GROSS PLASTIC DEFORMATION AND COLLAPSE

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Zero Curvature Method and Protection Criterion Against Plastic Collapse

A New Method for Preventing Plastic Collapse of Ellipsoidal Head under Internal Pressure

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

A Numerical Computation Method on Plastic Collapse Theorem

A 5% Maximum Principal Strain Criterion to Prevent Gross Plastic Deformation

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Dual Assessment Criterion and Its Programmed Application of Collapse Failure of Pressure Vessels

Plastic Collapse Stresses for Pipes With Circumferential Twin Flaws Using Combination Rules

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Progressive Collapse Safety Evaluation of Truss Structures Considering Material Plasticity

Plastic Collapse Stresses Based on Flaw Combination Rules for Pipes Containing Two Circumferential Similar Flaws

New Constraint Parameters Based on Crack Tip Plastic Zone: Theoretical Derivations and Effectiveness Verification

PLASTIC ANALYSES OF STRUCTURES AND FAILURE ASSESSMENT OF PRESSURE VESSELS AND PIPING WITH VOLUMETRIC DEFECTS

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Plastic Collapse Moment for Weld Overlay Pipe with Multiple Circumferential Flaws

An efficient adaptive polygonal finite element method for plastic collapse analysis of solids