Abstract:Bending stresses at incipient plastic collapse for pipes with circumferential surface cracks are predicted by net-section stress approach. Appendix C-5320 of ASME B&PV Code Section XI provides an equation of bending stress at the plastic collapse, where the equation is applicable for both inner and outer surface cracks. That is, the collapse stresses for pipes with inner and outer surface cracks are the same, because of the pipe mean radius at the cracked section being entirely the same. Authors considered the separated pipe mean radii at the cracked ligament and at the uncracked ligament. Based on the balances of axial force and bending moment, equations of plastic collapse stresses for both inner and outer cracked pipes were developed. It is found that, when the crack angle and depth are the same, the collapse stress for inner cracked pipe is slightly higher than that calculated by the Appendix C equation, and the collapse stress for outer cracked pipe is slightly lower than that by the Appendix C equation, as can be expected. The collapse stresses derived from the three equations are almost the same in most instances. However, for less common case where the crack angle and depth are very large for thick wall pipes, the differences among the three collapse stresses become large. Code users pay attention to the margins of plastic collapse stresses for outer cracked pipes, when using Appendix C equation.

Plastic Collapse Moment for Weld Overlay Pipe with Multiple Circumferential Flaws

Prediction of Plastic Collapse Moments for Circumferential Cracked Pipes with Weld Overlays

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Verification of Prediction Method of Plastic Collapse Stress for Pipe with Weld Overlay

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Collapse Stresses for Pipes With Circumferential Twin Flaws Using Combination Rules

Plastic Collapse Stresses Based on Flaw Combination Rules for Pipes Containing Two Circumferential Similar Flaws

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Cyclic Testing Of Moment Connections Upgraded With Weld Overlays

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Prediction of Collapse Stress for Pipes with Arbitrary Multiple Circumferential Surface Flaws

Empirical Correction Factor to Estimate the Plastic Collapse Bending Moment of Pipes with Circumferential Surface Flaw

Failure Bending Moment of Pipes Containing Multiple Circumferential Flaws with Complex Shape

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Plastic Limit Load Analysis of Defective Pipelines

Plastic Collapse Stresses for Pipes with Inner and Outer Circumferential Cracks

Practical Computation of the Plastic Collapse Limit of Defective Pipelines under Complex Loadings

Plastic Collapse Analysis of Defective Pipelines under Multi-Loading Systems

Effect Of Pressure On Plastic Collapse Under The Combined Bending And Torsion Moments For Circumferentially Surface Flawed Pipes

Safety analysis of pressure piping containing incomplete penetration under combined loads