Abstract:Ellipsoidal head is a common end closure of pressure vessel. Plastic collapse is a crucial failure mode considered in the design of ellipsoidal head subjected to internal pressure. Internally pressurized ellipsoidal head tends to be hemisphere (geometric strengthening) due to the effect of material hardening before plastic collapse occurs, which enhances load carrying capacity of ellipsoidal head. However, in the current pressure vessel codes such as ASME BPVC.VIII.1 and BPVC.VIII.2, EN 13445-3, and Chinese codes GB/T 150.3 and JB 4732, design methods based on linear elastic or perfectly-plastic theory are used to prevent plastic collapse of ellipsoidal head, leading to conservative design. Therefore, we developed a new method for preventing plastic collapse of ellipsoidal head under internal pressure, considering the effects of material hardening and geometric strengthening. The new method was developed on basis of our previous extensive work on finite element analysis and experiments for plastic collapse of internally pressurized ellipsoidal heads. The new method provides sufficient margin of safety by checking against the experimental bursting results of full-scale ellipsoidal heads with various geometries, various material types and various manufacturing methods. Compared with the design methods in the current pressure vessel codes, the new method shows an advantage of economy. This new method had been approved by China Standardization Committee on Boilers and Pressure Vessels, and at present it has been introduced into the Chinese pressure vessel code.

LOAD AND RESISTANCE FACTOR DESIGN OF DUAL CRITERION AGAINST GROSS PLASTIC DEFORMATION AND COLLAPSE

Dual Assessment Criterion and Its Programmed Application of Collapse Failure of Pressure Vessels

A New Protection Criterion Against Plastic Collapse

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Zero Curvature Method and Protection Criterion Against Plastic Collapse

RATIONAL DESIGN OF CRANE RUNWAY GIRDERS

Plastic Collapse Stresses for Pipes With Circumferential Twin Flaws Using Combination Rules

Ductility Factors of Steel Plates Subjected to Non-Uniform Compression and Section Classification for Seismic Design

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

A 5% Maximum Principal Strain Criterion to Prevent Gross Plastic Deformation

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Plastic Collapse Stresses Based on Flaw Combination Rules for Pipes Containing Two Circumferential Similar Flaws

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

The Unified Limit Load Solution of Fiber-reinforced Concrete Cylinders Considering the Strain Softening of Material

Behavior and Design of Slender Concrete-Filled Wide Rectangular Steel Tubular Columns under Axial Compression

Plastic Limit Load Analysis of Defective Pipelines

Empirical Correction Factor to Estimate the Plastic Collapse Bending Moment of Pipes with Circumferential Surface Flaw

RESEARCH ON LOCAL BUCKLING OF DODECAGONAL SECTION DOUBLE SKINNED CONCRETE-FILLED STEEL TUBE SHORT COLUMN

A New Method for Preventing Plastic Collapse of Ellipsoidal Head under Internal Pressure

Application Scope of Limit Load Criterion for Ductile Material Pipes with Circumferentially External Cracks

Practical Computation of the Plastic Collapse Limit of Defective Pipelines under Complex Loadings