Ductility Factors of Steel Plates Subjected to Non-Uniform Compression and Section Classification for Seismic Design

Bo Fu,Gen-Shu Tong

2013-01-01

Abstract:Considering geometric and material nonlinearities,residual stress and initial geometric imperfections,simply supported steel plates under bending and compression were analyzed.The bending moment-edge compressive strain curves and moment-curvature curves were obtained.Based on the definitions of ductility factors,the relations between ductility factors and normalized slenderness of plates were obtained from the two kinds of curves and approximate formulas for both ductility factors were proposed.The analysis reveals that the ductility factor determined from the moment-curvature curve is less than that from the moment-strain curves.According to the classification of steel cross-sections for seismic design,the paper tentatively proposed the limiting values of width-to-thickness ratio.The limiting values were obtained by using the relationship between the system ductility and the cross-sectional curvature ductility,and based on whether or not an overstrength factor was included in the structural performance factor.A formula was suggested to relate the limiting values of width-to-thickness ratio to the structural performance factor.