Abstract:This paper deals with the dynamic increase factor (DIF) to consider the dynamic effects in the nonlinear static analysis of RC frame buildings subjected to sudden loss of a first-storey column. The study applies nonlinear static and dynamic analyses and focuses on typical seismically designed reinforced concrete buildings. The analysis of these structures until failure requires considering both the geometric and material nonlinearities since the behaviour following sudden column loss is inelastic and possibly implicate catenary effects. Moreover, quantifying the robustness of this type of structure requires the implementation of detailed three-dimensional models. This paper investigates the effects of building properties including the number of storeys, the number of bays and the location of the removed column. The results show that the buildings designed for seismic loads reveal enough capacity to avoid the global collapse, both considering and neglecting the contribution of RC floor slab. The progressive collapse resistance is greater for the external column removal scenario than for the internal column removal scenario. Both the number of floors and the number of bays are not very sensitive parameters for the progressive collapse resistance. The nonlinear static approach leads to a conservative estimation of the collapse resistance when a DIF of 2 is used as the dynamic amplification factor. For the study cases, the response of the building subjected to column loss never involves the hardening phenomenon associated with the catenary action. In this situation, the DIF decreases monotonically with increasing vertical deflection. The lower bound value of DIF is very close to 1, which is the typical value of structures that fully develop their inelastic behaviour after column removal. The simulation results show that the floor slabs can greatly improve the progressive collapse resistance, but have a minor influence on the dynamic increase factor. Thus, the simplification of the problem into 3D bare frames can lead to an accurate estimation of DIF with less computationally intensive analyses.

Curvature Ductility-Based Seismic Force Reduction Factor of Flexure-Type Structure

Seismic Force Modification Factor for Ductile Structures

SEISMIC-FORCE-MODIFICATION FACTOR FOR STRUCTURES WITH BILINEAR ELASTOPLASTIC MODEL

SEISMIC FORCE MODIFICATION FACTORS FOR STRUCTURES WITH SHEAR-SLIP HYSTERETIC MODEL

Ductility Factors of Steel Plates Subjected to Non-Uniform Compression and Section Classification for Seismic Design

Spectra of Seismic Force Reduction Factors of MDOF Systems Normalized by Two Characteristic Periods

Inelastic Displacement Amplification Factor for Ductile Structures with Constant Strength Reduction Factor

Static and dynamic inelastic P -Δ effect for seismic design

Seismic Force with Different Ductility Factor in Strength Degrading System

Dynamic P-△ Effects on Seismic Force Modification Factors

Determining Experimental Ductile Behavior of Composite Walls Considering Second-Order Effects: A Case Study for Multi-Celled CFST Walls

System-Level Nonlinear Seismic Response Characteristics Of Steel Structures

Estimation of system-level ductility demands for multi-story structures

Curvature Modal Analysis Forbending Structures

Torsional ductility spectrum for predicting ductility distribution in simple asymmetric‐plan structures

Limited ductility design of reinforced concrete columns for tall buildings in low to moderate seismicity regions

Quantification of seismic demands of damage-control tension-only concentrically braced steel beam-through frames (TCBSBFs) subjected to near-fault ground motions based on the energy factor

Evaluation of Performance and Storey Drift Ratio Limits of High-Rise Structural Systems with Separated Gravity and Lateral Load Resisting Systems Using Time History Analysis and Incremental Dynamic Analysis

Deformation Characteristics and Influence Factors of Shear Force Lateral Stiffness Matching Index for Non-Rigid Plate Bent Frame Structures

Performance-Based Seismic Design for Bridge Bents Retrofitted with BRBs Using the Ductility Demand Spectra of SDOF Oscillators with Bilinear Fuses

Dynamic Increase Factor for Nonlinear Static Analysis of RC Frame Buildings Against Progressive Collapse