Abstract:Modified two-surface model (M2SM) is one of the steel elasto-plastic hysteretic constitutive models that consider both analysis accuracy and efficiency. However, when M2SM is used for complex strain history, sometimes the results are irrational due to the limitation of stress-strain path judgment. In this paper, the defect of M2SM was re-modified by improving the judgment of stress-strain paths. The accuracy and applicability of the improved method were verified on both material and structural level. Based on this improvement, the nonlinear time-history analysis was carried out for a deck-through steel arch bridge with a 200 m-long span under the ground motions of Chi-Chi earthquake and Niigata earthquake. In the analysis, we compared the results obtained by hysteretic constitutive models of improved two-surface model (I2SM) presented in this paper, M2SM and the bilinear kinematic hardening model (BKHM). Results show that, although the analysis precision of displacement response of different steel hysteretic models differs little from each other, the stress-strain responses of the structure are affected by steel hysteretic models apparently. The difference between the stress- strain responses obtained by I2SM and M2SM cannot be neglected. In significantly damaged areas, BKHM gives smaller stress result and obviously different strain response compared with I2SM and M2SM, and tends to overestimate the effect of hysteretic energy dissipation. Moreover, at some position with severe damage, BKHM may underestimate the size of seismic damaged areas. Different steel hysteretic models also have influences on structural damage evaluation results based on deformation behavior and low cycle fatigue, and may lead to completely different judgment of failure, especially in severely damaged areas.

Seismic Force with Different Ductility Factor in Strength Degrading System

SEISMIC FORCE MODIFICATION FACTORS FOR STRUCTURES WITH SHEAR-SLIP HYSTERETIC MODEL

Seismic Force Modification Factor for Ductile Structures

SEISMIC-FORCE-MODIFICATION FACTOR FOR STRUCTURES WITH BILINEAR ELASTOPLASTIC MODEL

Inelastic Displacement Amplification Factor for Ductile Structures with Constant Strength Reduction Factor

Dynamic P-△ Effects on Seismic Force Modification Factors

Seismic Force Modification Factors for Modified-Clough Hysteretic Model

Inelastic Yielding Strength Demand Coefficient Spectra

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Effect of Hysteretic Constitutive Models on Elasto-Plastic Seismic Performance Evaluation of Steel Arch Bridges

Spectra of Seismic Force Reduction Factors of MDOF Systems Normalized by Two Characteristic Periods

Yield Point Spectra with constant ductility

Curvature Ductility-Based Seismic Force Reduction Factor of Flexure-Type Structure

Static and dynamic inelastic P -Δ effect for seismic design

Inelastic Spectrum Normalization Considering P-Δ Effects

Improved Ultra-Low Cycle Fatigue Fracture Models for Structural Steels Considering the Dependence of Cyclic Damage Degradation Parameters on Stress Triaxiality

STRENGTH DETERIORATION MODEL BASED ON EFFECTIVE HYSTERETIC ENERGY DISSIPATION FOR RC MEMBERS UNDER CYCLIC LOADING

Influence of Damage and Degradation Index on Steel Frame under Severe Earthquakes

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Influencing factors analysis of degradation and damage and the effect on steel frame

Research on the Multi-Shear Spring Model for Circular-Section Steel Piers