Abstract:Elbows are the type of components widely used in a piping system, and are particularly important from the point of view of structural behaviour. In practice, the existence of cracks in excess of the defect limit cannot be excluded. So it is very important to know the effect of cracks on limit loads of elbows for integrity assessment of the piping system. The existing closed-form limit loads for axial cracked elbows under in-plane bending moment are either too conservative or inadequate, therefore, the present studies focused on limit loads of elbows with axial cracks and the crack configurations were assumed to be constant-depth rectangle, subjected to in plane opening and closing bending moments respectively. The crack-like defects were postulated to be in crown of elbows with different crack sizes. The limit loads and residual strength factors (RSFs) (ML/M0L )of cracked elbows with various ratios of t/rm and relative bending radius R/rm were investigated in detail, by using of three-dimensional (3D) non-linear finite element (FE) analyses, assuming elastic perfectly-plastic material behaviour and taking geometric nonlinearity into account. The non-linear finite element (FE) analyses indicate that under the open/close bending modes, elbows exhibit different behaviour obviously at the elastic plastic states. The results from comprehensive parametric studies indicate that the limit loads of cracked elbows may reduce with the increasing of crack length, and these trends are more serious for long radius elbows. Generally speaking, the thickness-radius ratio t/rm of elbow has insignificant effects on RSFs. Based on extensive limit load numeric data and comprehensive parametric studies, the revised closed form equations for cracked elbows involving effect of tangent pipes, were established. The results can be used for Fitness-For-Service assessment of elbow.

Application Scope of Limit Load Criterion for Ductile Material Pipes with Circumferentially External Cracks

PLASTIC COLLAPSE STRESSES FOR THICK WALL PIPES WITH EXTERNAL CRACKS

Plastic Collapse Stresses for Pipes with Inner and Outer Circumferential Cracks

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Allowable Cracks Related to Penetration for Part-Through Cracks in Pipes Subjected to Bending Stresses

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

1003 Experimental Study on Limit Load Criterion for Pipe with Crack Modelled in Its Shape

Prediction Method for Plastic Collapse of Circumferentially Cracked Pipes Subjected to Combined Bending and Torsion Moments

Limit Loads for Cracked Elbows under In-Plane Bending Moment

Prediction Method For Plastic Collapse Of Pipes Subjected To Combined Bending And Torsion Moments

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Limit loads for part-through surface axially cracked elbows under internal pressure

Empirical Correction Factor to Estimate the Plastic Collapse Bending Moment of Pipes with Circumferential Surface Flaw

Limit Load Estimation Method for Pipe with an Arbitrary Shaped Circumferential Surface Flaw

Allowable External Flaws and Acceptance Standards for High Toughness Ductile Pipes Subjected to Bending Moment and Internal Pressure

COLLAPSE LOADS FOR CRACKED ELBOWS UNDER INTERNAL PRESSURE

Characteristics of Allowable Axial Cracks for Pressurized Pipes Governed by Limit Load Criteria

Experimental Verification on Limit Load Estimation Method for Pipes with an Arbitrary Shaped Circumferential Surface Flaw

Experimental Investigation on the Limit Load Estimation Method for Pipes Containing a Circumferential Surface Flaw with Complicated Shape

Effect Of Pressure On Plastic Collapse Under The Combined Bending And Torsion Moments For Circumferentially Surface Flawed Pipes

Analytical Limit Loads for Tube Sections with Circumferential Degradation