Abstract:Bending stresses at incipient plastic collapse for pipes with circumferential surface cracks are predicted by net-section stress approach. Appendix C-5320 of ASME B&PV Code Section XI provides an equation of bending stress at the plastic collapse, where the equation is applicable for both inner and outer surface cracks. That is, the collapse stresses for pipes with inner and outer surface cracks are the same, because of the pipe mean radius at the cracked section being entirely the same. Authors considered the separated pipe mean radii at the cracked ligament and at the uncracked ligament. Based on the balances of axial force and bending moment, equations of plastic collapse stresses for both inner and outer cracked pipes were developed. It is found that, when the crack angle and depth are the same, the collapse stress for inner cracked pipe is slightly higher than that calculated by the Appendix C equation, and the collapse stress for outer cracked pipe is slightly lower than that by the Appendix C equation, as can be expected. The collapse stresses derived from the three equations are almost the same in most instances. However, for less common case where the crack angle and depth are very large for thick wall pipes, the differences among the three collapse stresses become large. Code users pay attention to the margins of plastic collapse stresses for outer cracked pipes, when using Appendix C equation.

Prediction Method For Plastic Collapse Of Pipes Subjected To Combined Bending And Torsion Moments

Prediction Method for Plastic Collapse of Circumferentially Cracked Pipes Subjected to Combined Bending and Torsion Moments

Effect Of Pressure On Plastic Collapse Under The Combined Bending And Torsion Moments For Circumferentially Surface Flawed Pipes

Effect of Torsion Moment on Failure Bending Moment for Circumferentially Cracked Pipe

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Evaluation of Torsion and Bending Collapse Moments for Pipes with Local Wall Thinning

ICONE19-43138 Prediction of Failure Bending Moment for a Pipe Containing Multiple Circumferential Cracks with Complex Shapes

Experimental Investigation of Failure Estimation Method for Circumferentially Cracked Pipes Subjected to Combined Bending and Torsion Moments

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Plastic Collapse Stresses for Pipes with Inner and Outer Circumferential Cracks

Technical Basis for Application of Collapse Moments for Locally Thinned Pipes Subjected to Torsion and Bending Proposed for ASME Section XI

Experimental Study on Failure Estimation Method for Circumferentially Cracked Pipes Subjected to Multi-Axial Loads

Experimental Investigation on the Failure Estimation Method of Cracked Cylinders Subjected to Multi-Axial Loads

Prediction of Collapse Stress for Pipes with Arbitrary Multiple Circumferential Surface Flaws

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

PLASTIC COLLAPSE STRESSES FOR THICK WALL PIPES WITH EXTERNAL CRACKS

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Prediction of Failure Bending Moment for a Pipe with an Arbitrary-Shaped Circumferential Flaw

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Inclusion of Torsion with Bending and Pressure Loads for Pipes with Thin-Wall Regions

Effect of Torsion on Collapse Bending Moment for 24-Inch Diameter Schedule 80 Pipes with Wall Thinning