Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. In a piping system, pipe bends are more flexible than straight pipes because of their curved geometry, supplemented by higher stress and strain concentration, leading to one of the crucial components in piping industries. Therefore, safe design of pipe bends is essential for smooth running of the piping system, and plastic collapse moment is one of its criteria. This paper utilizes three-dimensional finite element analyses to model empirical solutions for the plastic collapse moment for different angled pipe bends subjected to combined pressure and in-plane closing, in-plane opening, and out-of-plane bending moments. Plastic collapse moments for 30∘ to 180∘ pipe bends are determined for elastic perfectly plastic and strain hardening materials, employing large geometry change option and internal pressure effect. It is observed from results that pressure effect is more prominent in thinner pipe bends of larger bend angle under all bending cases. For in-plane opening and out-of-plane bending moments, collapse moment increases and then decreases with increase in pressure intensity for all sizes of pipe bend. However, for in-plane opening bending moment, collapse moments keep on decreasing for thicker ([math] = 11.33) pipe bends. Finally, the study presents new improved plastic collapse moment solutions for different angled pipe bends under bending moment and internal pressure, derived from the finite element results of elastic perfectly plastic and strain hardening material models.

Technical Basis for Application of Collapse Moments for Locally Thinned Pipes Subjected to Torsion and Bending Proposed for ASME Section XI

Evaluation of Torsion and Bending Collapse Moments for Pipes with Local Wall Thinning

Effect of Torsion on Collapse Bending Moment for 24-Inch Diameter Schedule 80 Pipes with Wall Thinning

Inclusion of Torsion with Bending and Pressure Loads for Pipes with Thin-Wall Regions

Effects of Bending Moment and Torsion on the Internal Pressure Limit Load of Locally Thinned Pipes

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Failure Experiments on Pipes with Local Wall Thinning Subjected to Multi-Axial Loads

Prediction Method For Plastic Collapse Of Pipes Subjected To Combined Bending And Torsion Moments

Prediction Method for Plastic Collapse of Circumferentially Cracked Pipes Subjected to Combined Bending and Torsion Moments

Proposal for Inclusion of Torsion in Section XI Flaw Evaluation Procedures for Pipes Containing Surface Crack-Like Flaws

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Effects of Torsion on Equivalent Bending Moment for Limit Load and Epfm Circumferential Pipe Flaw Evaluations

Effects of Bending Moment and Torsion on the Burst Pressure of Locally Thinned Pipes

Inclusion of Torsion Loads in Section Xi Flaw Evaluation Procedures for Pipes Containing Circumferential Planar Surface Crack-Like Flaws on the Basis of Limit Load Analysis

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Empirical Correction Factor to Estimate the Plastic Collapse Bending Moment of Pipes with Circumferential Surface Flaw

Effect Of Pressure On Plastic Collapse Under The Combined Bending And Torsion Moments For Circumferentially Surface Flawed Pipes

Effect of Torsion Moment on Failure Bending Moment for Circumferentially Cracked Pipe

Development of new improved plastic collapse moment equations of pressurized different angled pipe bends under bending moments

Plastic Collapse Stresses for Pipes with Inner and Outer Circumferential Cracks

Failure Bending Moment of Pipes Containing Multiple Circumferential Flaws with Complex Shape