Abstract:Allowable stresses for pipes with circumferential flaws are provided by the ASME Code Section XI. The stresses for the high toughness pipes are determined by fully plastic collapse stresses and safety factors. The plastic collapse stresses are estimated by limit load criteria, which are also provided by the ASME Code Section XI. When applied stresses of the pipes at the flaw locations are less than the allowable stresses, the flaws are acceptable for the end-of-evaluation period. The allowable stresses are categorized for various service-level conditions of the plant operation. When pipe walls are thin, part-through flaws can easily develop into through-wall flaws, and the likelihood of coolant leakage is high. The ASME Code Section XI provides final allowable flaw angles of through-wall flaws that are a limit on the length of part-through wall flaws for thin-walled pipes. The final allowable angles are currently applied to pipes in order to maintain structural tolerance if the part-through flaws become through-wall flaws. To ensure that this stability is not compromised, plastic collapse stresses for through-wall flaws are combined with the allowable stresses. However, the final allowable angles of through-wall flaws are not identified for thin-walled pipes. This paper compares plastic collapse stresses of through-wall flaws and allowable stresses of part-through flaws for pipes. The comparison of these stresses is used to derive the final allowable angles of through-wall flaws. The angles can be expressed either in the form of exact solutions or as conventional options that are appropriate for various service-level conditions.

Allowable External Flaws and Acceptance Standards for High Toughness Ductile Pipes Subjected to Bending Moment and Internal Pressure

Stability of Allowable Flaw Angles for High Toughness Ductile Pipes Subjected to Bending Stress in the ASME Code Section XI

Failure Bending Moment for Pipes with an Arbitrary-Shaped Circumferential Flaw

Failure Bending Moment of Pipes Containing Multiple Circumferential Flaws with Complex Shape

Failure Bending Stresses for Small Diameter Thick-Wall Pipes

Limit bending moment for pipes with two circumferential flaws under combined internal pressure and bending

Experimental Verification on Limit Load Estimation Method for Pipes with an Arbitrary Shaped Circumferential Surface Flaw

Experimental Investigation on the Limit Load Estimation Method for Pipes Containing a Circumferential Surface Flaw with Complicated Shape

Prediction of Failure Bending Moment for a Pipe with an Arbitrary-Shaped Circumferential Flaw

Inclusion of Torsion Loads in Section Xi Flaw Evaluation Procedures for Pipes Containing Circumferential Planar Surface Crack-Like Flaws on the Basis of Limit Load Analysis

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Limit Load Estimation Method for Pipe with an Arbitrary Shaped Circumferential Surface Flaw

Allowable Cracks Related to Penetration for Part-Through Cracks in Pipes Subjected to Bending Stresses

Application Scope of Limit Load Criterion for Ductile Material Pipes with Circumferentially External Cracks

Characteristics of Allowable Axial Cracks for Pressurized Pipes Governed by Limit Load Criteria

Proposal for Inclusion of Torsion in Section XI Flaw Evaluation Procedures for Pipes Containing Surface Crack-Like Flaws

Inclusion of Torsion with Bending and Pressure Loads for Pipes with Thin-Wall Regions

Effects of Torsion on Equivalent Bending Moment for Limit Load and Epfm Circumferential Pipe Flaw Evaluations

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Prediction of Collapse Stress for Pipes with Arbitrary Multiple Circumferential Surface Flaws