Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Effects of Process Parameters on FPE in Radial Forging Processes

Multi-objective optimization of concave radial forging process parameters based on response surface methodology and genetic algorithm

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Investigation of Rigid Particle Flow Method in Simulating Free Forging Processes

Analysis on the Process of Cold Enclosed Precision Forging of Starlike Sleeve

Application of processing maps and numerical modelling for identification of parameters and limitations of hot forging process of 80MnSi8-6 steel

Investigation of FM heavy forging process by the Moiré method Part III: A direct forging process standard

Stretching of Heavy Forgings with a Concave Anvil

NUMERICAL SIMULATION AND EXPERIMENTATION CUP-SHAPED THIN-WALLED INNER RECTANGULAR GEAR FORMED BY SPINNING

The Significance of Experiment in the Finite Element Analysis of a Pulley Forming Process

Parametric Modeling and Simulation of the Gear Shaping Process of Floating Support Friction Disk

Parameter optimization in hot precision forging process of synchronizer ring based on grey relational analysis and response surface method

Multi-objective optimization of parametric design for profile ring rolling process based on residual stress control

Research on plastic deformation transfer and distribution of large-diameter thin-walled metal ring parts in double-roll pendulum hot rotary forging process

Finite element analysis of heavy forging processing with JTS method

Multi-objective optimization of forging surface structure parameters of radial forging die with cycloidal

The Application of Finite Element Method for Analysis of Cross-Wedge Rolling Processes-A Review

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Effect of Shape Tool Parameters on the Performance of Cold Circular Three-Dimensional Pilger Cross-Section Roll Forming