Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Investigation of FM heavy forging process by the Moiré method Part III: A direct forging process standard

Radial forging force and spread for rectangular cross-sectional forging

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

Study on isothermal precision forging process of an aluminum alloy ring seat

An Upper Bound Solution of Forging Load in Cold Radial Forging Process of Rectangular Cross-Section Billet

Modeling research on FM forging process of heavy low-pressure turbine rotor

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

Improvement of Axial Forging Process for Spline Shaft by Die Design

Parameter optimization in hot precision forging process of synchronizer ring based on grey relational analysis and response surface method

Microstructure Refinement and Crack Initiation in the Forging Process

Influence of Anvil Shape and Process Parameters on Mandrel Forging of Large Cylindrical Forgings

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils

Research on Divided Flow Method and Temperature Effect of the Incremental Rolling Forming Process for Spline Shaft

Study of workability limits of porous materials under different upsetting conditions by compressible rigid plastic finite element method

Investigation on hollow steel ingot forging process of heavy cylinder forging

Optimization of multi-directional forging parameters of large-scale Mg-Gd-Y-Zn-Zr alloy forged part guided by finite element simulation

Study on Precision Forging Technology for A Complex-Shaped Light Alloy Forging

Dynamic Softening Mechanism on Steel of ASME SA508-3 During Hot Working

Brief analysis on mold design and forging process of a typical forging product

Numerical Modeling and Anvil Design of High-Speed Forging Process for Railway Axles