Abstract:Purpose – The purpose of this paper is to build a flow stress model and microstructure evolution models which can be used to fulfill the multi-physics prediction of hot forging process, in this way the process design can be virtually verified and optimized. This is especially crucial for micro-alloyed steel forging which microstructure determines the component properties, since the downstream quenching is usually not needed. Design/methodology/approach – First, hot compression tests have been completed; second, experimental data are used to build the flow stress model and models for microstructure evolution; third, programming has been finished to integrate the proposed models into the commercial finite element method (FEM) code; fourth, case study is conducted to simulate multi-stage hot forging process of micro-alloyed steel F38MnV piston; and fifth, simulation results are validated by experiment. Findings – First, simulation results in grain size and phase volume fraction are in well agreement with experimental ones; second, the austenite grain is dramatically refined by the dynamic recrystallization in pre-forging process and static recrystallization in the two intervals has no obvious change during the following final forging and cooling above the Ae3 temperature; third, during the cooling process below the Ae3 temperature, ferrite and pearlite transformation begin from the thin skirt to the thick skirt and piston bottom because of different cooling speeds at different areas. Originality/value – First, flow stress model, dynamic recrystallization model, static recrystallization model, austenite grain growth model and phase transformation models are established for a micro-alloyed steel; second, the multi-physics FEM simulation of multi-stage hot forging of industrial piston has been conducted and verified by experiment, which show good agreement.

A Study of Critical Reduction for Closing Pores in Heavy Forgings

A STUDY OF LOCAL EFFECTS OF PORE AND CRITICAL REDUCTION FOR PORE CLOSURE IN HEAVY INGOTS

Analysis of Internal Cracks in High Carbon Casting Bloom Induced by Soft Reduction Process and Its Improvement Using Numerical Simulations and Industrial Experiments

Simulation of cylindrical up setting of porous materials by finite element method

A Porosity Closure Model for the Integrated Casting and Forging Process of Aluminum Alloy and Its Application

Void Closing Conditions for Solid Cylinders During Hot Forging

Analysis of laminated crack defect in the upsetting process of heavy disk-shaped forgings

Microstructure Optimization of Heavy Forgings Based on Composite Design

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

Numerical Simulation of Temperature Field and Stress Field for and Axial Crack Analysis of Heavy-wall Centrifugally Cast Hollow Bloom

Numerical simulation of casting-forging integrated breakdown process

A criterion for void closure in large ingots during hot forging

Influence of Differential Reduction Rate in Adjacent Roll Reduction Zone on Internal Cracks of High Carbon Bloom Induced by Mechanical Soft Reduction

Computer Modeling of Property-controlled Forging Process for Heavy Forgings

A Pass Planning Method for Multi-Hit Stretching of Heavy Forgings by Integration of a Semi-Analytical Technique and Degrees-Reduced Finite Element

A General Simulation Technology for Forging with Considering the Evolution of Voids, Grains and Cracks

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Numerical Prediction on Microstructure Evolution for Multi-Stage Hot Forging of Micro-Alloyed Piston

Influence of process conditions and pore morphology on the closure rate of pores in hot rolling of steel

The Numerical Simulation of Large Cylinder Forging in Forging Process under High Temperature