Abstract:To optimise the benefits of the deep-rolling process in the service life context of treated components, the process application must be investigated. In addition to the reduction in surface roughness and near-surface material strengthening, compressive residual stresses are introduced, which are primarily responsible for the increase in service life for components, especially in the case of high-strength steel materials. A numerical parameter sensitivity analysis is performed in order to investigate the introduced residual stresses in detail. For this purpose, a validated deep-rolling simulation model is used, which replicates the deep rolling of a railway axle made of the high-strength steel material 34CrNiMo6. The model is based on an elastic-plastic Chaboche material model parameterised on uniaxial tensile and LCF test results and validated with residual stress measurements. Using this model as a basis, the effect of the main process parameters deep-rolling force, feed rate, friction coefficient, number of overruns, tool geometry, and shaft geometry on the resulting residual stress state are investigated. The results reveal that the deep-rolling force has the most significant influence on the introduced residual stress state and should therefore be highlighted. In the case of applying a deep-rolling force of more than 10 kN, maximum compressive residual stresses of around − 1000 MPa are introduced, and a strong saturating behaviour is shown. Maximum compensating tensile residual stresses of + 100 MPa occur below the surface. The main influence of the deep-rolling force is the effective depth achieved, which is determined by the depth of the zero crossing. This varies from 1 mm with an applied force of 2 kN to more than 3.5 mm with 20 kN. Furthermore, the results are analysed to conclude suggestions for the process's applicability, and a proposal for an optimised deep-rolling treatment is presented. There multiple deep rolling with decreased deep-rolling forces is used to achieve a comparably optimised residual stress state. In summary, with the presented results, a contribution to a deeper understanding of the deep-rolling process can be achieved; the influence of the most important process parameters on the residual stress in-depth profiles is established; an optimisation proposal is presented; and correlations are found. Thus, the base work for further fatigue strength assessments and the optimisation of the deep-rolling process regarding the increase of service is laid.

Influence of process conditions and pore morphology on the closure rate of pores in hot rolling of steel

Experimental and FE analysis of void closure in hot rolling of stainless steel

A STUDY OF LOCAL EFFECTS OF PORE AND CRITICAL REDUCTION FOR PORE CLOSURE IN HEAVY INGOTS

Adaptive Pass Scheduling for Roughness Control in Cold Rolling

Influence of the Carbon Content on the Surface Integrity of Deep Rolled Steels

Recrystallization and grain growth in hot rolling

Experimental study and numerical simulation of iron oxide scales mechanical behavior in hot rolling

The Cracks on Slab Corner During Hot Rolling Process

Dynamic Recrystallization Behavior of Low‐Carbon Steel during the Flexible Rolling Process: Modeling and Characterization

Future Research Potentials of Hot Rolling Process: A Review

Research on the Mechanism and Processability of Roll Forming

Numerical simulation of void elimination in the billet during hot shape rolling processes based on the Gurson–Tvergaard–Needleman model

Establishment of Thermal Ductile Fracture Criterion for As-Cast 42CrMo Steel and Its Application in Hot Ring Rolling Process

Numerical parameter sensitivity analysis of residual stresses induced by deep rolling for a 34CrNiMo6 steel railway axle

Influence of deep rolling at different temperatures on Near-Surface and mechanical properties of a Maraging C250 steel

Effect of Cold Rolling Reduction Rate on the Microstructure and Properties of Q&P Steel with a Ferrite-Pearlite Initial Structure

Damage Initiation of 15V38 Steel Bar during Square‐to‐Round Hot Rolling Process

Multi-Scale Modeling of Microstructure Evolution during Multi-Pass Hot-Rolling and Cooling Process

Effect of Rolling Process Parameters on Transverse Cracks on the Surface of Q345 Steel

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts