Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Investigation of FM heavy forging process by the Moiré method Part III: A direct forging process standard

The Investigation of the FM Heavy Forging Process by the Moiré Method Part II: Consecutive Reduction Results

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Design and analysis of the mandrel structure for a composite S-shaped inlet

Staggered Anvil and Rotation Processes for Refining and Homogenizing Centimeter-Scale Grains During Fm Forging of Superheavy Ingots

Investigation on hollow steel ingot forging process of heavy cylinder forging

Modeling research on FM forging process of heavy low-pressure turbine rotor

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

Stretching of Heavy Forgings with a Concave Anvil

A modified Johnson-Cook model to determine plastic flow behavior of Fe-30Mn-9Al-0.8 C low-density steel during warm multiaxial forging

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Microstructure Refinement and Crack Initiation in the Forging Process

The microstructure, texture evolution and plasticity anisotropy of 30SiMn2MoVA high strength alloy steel tube processed by cold radial forging

ON FORGING FORMING FORCE IN THE COMPOSITE TECHNOLOGY OF CROSS WEDGE ROLLING ( CWR ) AND FORGING FOR UNIVERSAL JOINT FORK

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

A new tube forging process for manufacturing hollow parts with inner flange at an arbitrary location

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Multi-ram Forge Process and Its Equipment Development

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

Parameter optimization in hot precision forging process of synchronizer ring based on grey relational analysis and response surface method

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM