Abstract:The microstructural changes in Fe-30Mn-9Al-0.8 C low-density steel upto equivalent strain 2.3 during multiaxial forging (MAF) and their impact on tensile strengthening have been thoroughly investigated. The processed sample at 0 pass, 1 pass, 3 pass, and 5 pass with 33% normal strain in each pass are characterized by X-ray diffraction (XRD) and electron backscattered diffraction (EBSD). The analysis of XRD confirms a noticeable increase in dislocation density progressing from 0.79 × 10 15 m −2 to 8.98 × 10 15 m −2 , attributed to a decrease in crystallite size and an increase in microstrain from 3.66 × 10 −3 to 6.8 × 10 −3 . The grain size reduces from 50 μm to 13 μm . The yield strength increases from 380 MPa to 1528 MPa, while the ultimate strength increases from 762 MPa to 1548 MPa after 5 passes. It is observed here that both dislocation density and grain boundaries contribute to strengthening the material. However, up to three passes, dislocation strengthening is significant. Additionally, a numerical framework is developed to model the evolution of dislocation density, grain size and yield strength at each stage of MAF. To emphasize the role of strengthening parameters in predicting the flow stresses in every MAF pass accurately, a material VUMAT subroutine in ABAQUS has been created for a modified Johnson-Cook (J-C) constitutive model that accounts for the role of increased dislocation density and grain size. The developed model demonstrates its capability to accurately capture essential material features, including equivalent strain, dislocation density, and grain size. Furthermore, it exhibits the ability to predict the yield strength approximately following each MAF pass.

Stretching of Heavy Forgings with a Concave Anvil

Technical Control of Multi-Pass Stretching of Low-Pressure Rotor Forging

Modeling research on FM forging process of heavy low-pressure turbine rotor

Simulation on New Chamfering Process of Nuclear Turbine Low-pressure Rotor Forging

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Staggered Anvil and Rotation Processes for Refining and Homogenizing Centimeter-Scale Grains During Fm Forging of Superheavy Ingots

Investigation of FM heavy forging process by the Moiré method Part III: A direct forging process standard

Rotary forging with multi-cone rolls

Research on Grain Refinement and Homogenization During the Mandrel Stretching Process of a Hollow Steel Ingot Used for Heavy Hydro-Generator Shaft

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils

New Drawing Technics of Large Forges

Research on Stretching of Cylinder with Different Anvils

Finite Element Simulation of Stretch Forging Using A Mesh Condensation Method

Research and Prospect of Shaft Stretching Technology

Dynamic Softening Mechanism on Steel of ASME SA508-3 During Hot Working

A Pass Planning Method for Multi-Hit Stretching of Heavy Forgings by Integration of a Semi-Analytical Technique and Degrees-Reduced Finite Element

A novel high-dynamic actuator based in-situ micro-forging process for wire arc additive manufacturing of aluminum alloy

Study of an Alternative Novel Cold Forging Process

A modified Johnson-Cook model to determine plastic flow behavior of Fe-30Mn-9Al-0.8 C low-density steel during warm multiaxial forging

Prediction of Deformation Behavior and Microstructure Evolution in Heavy Forging by FEM

Improving the Deformation Uniformity Within Forgings by Applying Preformed Optimization Based on FEM