Abstract:Rod fastening rotor (RFR), as a typical rotor structure of gas turbine which is different from the integral rotor, is comprised of a set of discs clamped together by a central tie rod or several tie rods on the pitch circle diameters. In process of machining, tolerances of the disc are inevitable, of which the parallelism error and mass imbalance are focused on in this paper. Firstly, the complex bending of RFR by accumulation of parallelism errors of discs is derived through the coordinate transmission. Then the static analysis of RFR is performed to obtain the additional pressure by the effect of unbalanced forces, which is related to the assembly angles and rotating speed, on contact surfaces using a linear hypothesis, based on which the distribution of contact pressure considering the original pre-tightening force is obtained. Then the Bifractal-Regular theory is adopted to acquire the micro-topography of the contact interface and derive the contact stiffness related to normal contact pressure, fractal upper length limit and regular shape of the contact interfaces. After that, the zero thickness element is introduced to obtain the equivalent stiffness matrices of the contact surface. In addition, the circumferential uniformly distributed rods are modeled as a spring element which provides additional bending stiffness for the RFR. Based on the analysis above, the dynamic model of the RFR-bearing system containing 10 discs is established using the Timoshenko beam element where the continuous part of the shaft is modeled by Timoshenko beam element considering shear effect. Finally, the multi -optimization is carried out on the vibration response by the coupled effects of both initial bending and mass imbalance of the RFR-bearing system through which the optimal assembly angles are obtained. The results show a good performance in decreasing vibration as well as bending of the RFR system.

Technical Control of Multi-Pass Stretching of Low-Pressure Rotor Forging

Stretching of Heavy Forgings with a Concave Anvil

Simulation on New Chamfering Process of Nuclear Turbine Low-pressure Rotor Forging

Modeling research on FM forging process of heavy low-pressure turbine rotor

Research on the Dynamic Recrystallization Behavior of 30cr2ni4mov LP Rotor Steel under Multi-Pass Deformation

Numerical Simulation and Experimental Study on Forging Process of Ultra-Super-critical HP-IP Rotor Steel

Experimental Study on Process of Precision Forging of an Aluminium-Alloy Rotor

A Pass Planning Method for Multi-Hit Stretching of Heavy Forgings by Integration of a Semi-Analytical Technique and Degrees-Reduced Finite Element

Computer Modeling of Property-controlled Forging Process for Heavy Forgings

Multi-Objective Optimization of Forging Process to Control the Microstructure and Damage of Material

Research on precise plastic forming technology of rotors with twist radial blades

Process simulation and parameter optimization of multi-layer multi-pass welded rotor

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Dynamic Analysis And Optimization On Assembly Parameters Of Rod Fastening Rotor System With Manufacturing Tolerances

Rotary forging with multi-cone rolls

Research on Precision Plastic Forming Technology of Rotors with Twist Radial Blades

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Modeling for warping prediction and control in cold rotary forging of round plate

3D FE modeling simulation of the double-roll hot rotary forging of large diameter thin-walled metal disk

Research on Grain Refinement and Homogenization During the Mandrel Stretching Process of a Hollow Steel Ingot Used for Heavy Hydro-Generator Shaft

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process