Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Simulation on New Chamfering Process of Nuclear Turbine Low-pressure Rotor Forging

Modeling research on FM forging process of heavy low-pressure turbine rotor

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Technical Control of Multi-Pass Stretching of Low-Pressure Rotor Forging

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Stretching of Heavy Forgings with a Concave Anvil

A new process chain combining cross-wedge rolling and isothermal forging for the forming of titanium alloy turbine blades

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

An innovative rotary rolling-forging process for manufacturing fork ring with extreme geometry

Technological Development of the Forged Low Pressure Rotor of Nuclear Turbine in China

A novel process for manufacturing large-diameter thin-walled metal ring: Double-roll pendulum hot rotary forging technology

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Research on Rotatory Deformation Uniformity and Compaction Effect of Super-heavy Hollow Steel Ingot

Design and simulation of cross wedge rolling process for hollow motor shaft

Investigation on hollow steel ingot forging process of heavy cylinder forging

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Research on plastic deformation transfer and distribution of large-diameter thin-walled metal ring parts in double-roll pendulum hot rotary forging process

Research on the Law of Affecting the Quality of forging Metallurgy Quality on the Quality of Wedge Horizontal Rolling Mold

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy