Abstract:In this work, a novel internal heat absorption technology using inorganic material rods is employed during the solidification process of steel ingots, aiming to control their solidification and improve the quality of the final product. The study investigates the effect of the insertion depth of inorganic materials on the solidification microstructure and macrosegregation of 2.5-ton 42CrMo ingots. The mechanical properties of samples from the product are also tested. A numerical simulation model for casting 2.5-ton ingots is established and implemented in Ansys Fluent fluid simulation software, with inorganic material rods set at different preset depths. The simulation explores the physical processes of the melting and floating of inorganic materials in molten steel, as well as their effects on the temperature and flow fields of the material. The results show that deeper insertion of inorganic materials (200 mm from the hot top) reduces the tendency for macrosegregation compared to that at the insertion depth of 100 mm. Specifically, the positive segregation area decreases by 10.35%, while the negative segregation area decreases by 15.32%. Moreover, deeper insertion results in a significant refinement of the solidification microstructure, ultimately enhancing the mechanical properties of the products machined from the ingots (i.e., the yield strength increased by 4.7%). The numerical simulation results indicate that as the placement depth of inorganic materials in the ingot mold increases, the cooling effect becomes more significant, the flow area of molten steel initiated by the inorganic materials expands, and the linear velocity of the double-circle flow increases. This further explains why the solidification quality of the ingots improves with the increasing placement depth of inorganic materials.

Research on Rotatory Deformation Uniformity and Compaction Effect of Super-heavy Hollow Steel Ingot

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

Research on Grain Refinement and Homogenization During the Mandrel Stretching Process of a Hollow Steel Ingot Used for Heavy Hydro-Generator Shaft

Investigation on hollow steel ingot forging process of heavy cylinder forging

Research on Heavy Hollow Ingot Forging Process

Staggered Anvil and Rotation Processes for Refining and Homogenizing Centimeter-Scale Grains During Fm Forging of Superheavy Ingots

Numerical Simulation Research on Mandrel reaming of Ring Steel Ingot

3D FE modeling simulation of the double-roll hot rotary forging of large diameter thin-walled metal disk

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Forming characteristics and mechanism of double-roll rotary forging for large-diameter and thin-walled metal discs

Microstructure Evolution and Flow Stress Model of a 20mn5 Hollow Steel Ingot During Hot Compression

New Drawing Technics of Large Forges

Research on plastic deformation transfer and distribution of large-diameter thin-walled metal ring parts in double-roll pendulum hot rotary forging process

A New Cold Rotary Forging Technology for Automotive Starter Guiding Cylinder with Internal Helical Involute Spline

The Influence of Insertion Depth of Inorganic Materials on Solidification Microstructure and Segregation of 2.5-ton 42CrMo Ingot

Hot Deformation Behavior and a Two-Stage Constitutive Model of 20mn5 Solid Steel Ingot During Hot Compression.

Optimization of numerical parameters and microstructure evolution on 2195 Al–Li alloy extrusion process

Optimization of multi-directional forging parameters of large-scale Mg-Gd-Y-Zn-Zr alloy forged part guided by finite element simulation

Research on Effects of Rolling-Drawing Deformation on Performance of Cu-10Ni-1Fe-1Mn Alloy