Abstract:<p>A feasibility research was firstly carried out to deposit SS316L nuclear nozzles directly on the large-curvature PWR (pressurized water reactor) main pipeline by using the well-designed spatial scanning path derived from self-developed slicing algorithm for 3D model during wire arc additive manufacturing (WAAM) and CMT (cold metal transfer) process. This study provides comprehensive and systematic microstructure and mechanical datum of the as-deposited WAAM-CMT SS316L nozzles. Microstructure characterizations indicate that almost no precipitates or hot crack except micron pores remain inside, and the molten pools present typical hierarchical structures: 1.26% granular-δ within cellular γ sub-grains in the bottom region, lathy-δ within cellular γ grains in the central region and 6.9% skeletal-δ within column dendritic γ grains in the top region, respectively. This can be attributed to the synergistic effects of temperature gradient and super-cooling degree under the repeated rapid solidification and annealing treatment cycle inherent to WAAM-CMT. Both 25 °C (RT) and 350 °C (HT) tensile properties are well above the ASTM A370 criteria due to the dispersion-strengthening of dendritic ferrite within hierarchical-structure molten pools, coupled with the pinning effects of high-density dislocation tangles and cellular sub-grain boundaries as well as the annihilation of harmful intermetallic precipitates like σ phase and carbides that could become crack initiation. Further studies should pay attention to inhibiting the surface oxidation of each depositing layer and reducing the amounts of internal micron pores and δ-ferrite so as to suppress Cr-Mo-Ni atomic segregation and improve inter-granular corrosion resistance preferably without post-weld heat treatment.</p>

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Grain Refinement During Plastic Forming of 316LN Steel Used in Nuclear Main Pipes

Simulation on New Chamfering Process of Nuclear Turbine Low-pressure Rotor Forging

Multi-scale simulation for the forming of a heavy vessel head considering the evolution of defects and microstructure

Research on Deformation Property of 316LN Nuclear Main Pipe Steel at Elevated Temperature

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

Research on Rotatory Deformation Uniformity and Compaction Effect of Super-heavy Hollow Steel Ingot

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

A General Simulation Technology for Forging with Considering the Evolution of Voids, Grains and Cracks

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Research on the Control Forging Processes for AP1000 Main Pipe

Development of Manufacture Technology for Main Pipe of Large-sized Nuclear Power

Modelling and Simulation of 316LN Steel Damage and Fracture During Hot Deformation

The Coarsening Effect of Sa508-3 Steel Used As Heavy Forgings Material

Research on the Dynamic Recrystallization Behavior of 316LN Steel under Multi-Pass Deformation

Modeling research on FM forging process of heavy low-pressure turbine rotor

Technical Control of Multi-Pass Stretching of Low-Pressure Rotor Forging

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Improving the Deformation Uniformity Within Forgings by Applying Preformed Optimization Based on FEM

Modeling and Simulation of Austenite Grain Evolution for Heavy Forging Steel 30cr2ni4mov Undergoing Hot Deformation

Fabrication of 316L nuclear nozzles on the main pipeline with large curvature by CMT wire arc additive manufacturing and self-developed slicing algorithm