Abstract:AP1000 nuclear power main pipe, a type of complicated thick-walled tube structure with both high and thick-walled nozzles, is one of the key parts in nuclear island. It is required to be manufactured by integral plastic forming technique. Up to now, no economical and efficient plastic forming process for AP1000 main pipe has been reported. To aim for forming the tube structure with a nozzle such as AP1000 main pipe, a radial upset-extruding (RUE) process was developed, in which the initial billet is an extruded tube with a hole. RUE process is an extrusion method which realizes radial outflow of the metal around the hole of tube billet through an axial upsetting force and restriction of dies. Thick-walled tube structure with a nozzle derived from AP1000 main pipe was simplified to be a thick-walled three-way pipe, on which RUE process was analyzed based. Combined with reduced scale model experiments, thermomechanical coupled finite element analysis integrated with recrystallization models of 316LN was performed to investigate RUE process. Metal flow, deformation distribution, recrystallization distribution, and extrusion load and clamping load in RUE process was analyzed. The experimental workpiece of pure lead based on reduced scale model validate metal flow behavior predicted by using numerical simulation. The results indicate that the essence of RUE process is to deflect the flow of the material around the orifice of the tube billet. The loads of dies are significantly sensitive to the initial forming temperature and the friction coefficient, while the impact of the extrusion velocity is negligible. RUE process could be used to form thick-walled tube structure with a nozzle, and it has a potential for solving the manufacture of AP1000 main pipe.

Grain Refinement During Plastic Forming of 316LN Steel Used in Nuclear Main Pipes

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Research on Deformation Property of 316LN Nuclear Main Pipe Steel at Elevated Temperature

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Research on the Dynamic Recrystallization Behavior of 316LN Steel under Multi-Pass Deformation

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Dynamic Softening Mechanism on Steel of ASME SA508-3 During Hot Working

Effect of Annealing Temperature on the Microstructure and Mechanical Properties of High-Pressure Torsion-Produced 316LN Stainless Steel

Optimization of Melt Treatment for Austenitic Steel Grain Refinement

Research on Grain Refinement and Homogenization During the Mandrel Stretching Process of a Hollow Steel Ingot Used for Heavy Hydro-Generator Shaft

Refinement mechanism of centimeter-grade coarse grains in as-cast Ti 2 AlNb-based alloy during multi-directional forging

Grain refinement in laser powder bed fusion: The influence of dynamic recrystallization and recovery

Research on the Control Forging Processes for AP1000 Main Pipe

Grain Refinement Mechanism and Microstructural Evolution of M50NiL Steel during Multi-directional Impact Forging

Postponing the Fracture Strain of Ultrafine-Grained 316LN Steel by Sequential Activations of Deformation Modes at 77 K

Grain growth behaviors during solution annealing based on the heterogeneous microstructure in hot rolled nuclear grade austenitic stainless steel

On the Constitutive Model of Nitrogen-Containing Austenitic Stainless Steel 316LN at Elevated Temperature.

Hot Radial Upset-Extruding Process for Tube Structure with a Nozzle of 316LN Stainless Steel

Deformation Behavior and Formability of Gradient Nano-Grained AISI 304 Stainless Steel Processed by Ultrasonic Impact Treatment