Abstract:As one of the indispensable actuating components in micro-systems, the shafted microgear is in great production demand. Microforming is a manufacturing process to produce microgears to meet the needs. Due to the small geometrical size, there are uncertain process performance and product quality issues in this production process. In this study, the shafted microgears were fabricated in two different scaling factors with four grain sizes using a progressively extrusion-blanking method. To explore the unknown of the process, grain-based modeling was proposed and employed to simulate the entire forming process. The results show that when the grains are large, the anisotropy of single grains has an obvious size effect on the forming behavior and process performance; and the produced geometries and surface quality are worsened; and the deformation load is decreased. Five deformation zones were identified in the microstructures with different hardness and distributions of stress and strain. The simulation by using the proposed model successfully predicted the formation of zones and revealed the inhomogeneous deformation in the forming process. The undesirable geometries of microgears including material unfilling, burr and inclination were observed on the shaft and teeth of gear, and the inclination size is increased obviously with grain size. To avoid the formation of inclination and material unfilling, the punch was redesigned, and a die insert was added to constraint the bottom surface of the gear teeth. The new products had then the better forming quality.

NUMERICAL SIMULATION AND EXPERIMENTATION CUP-SHAPED THIN-WALLED INNER RECTANGULAR GEAR FORMED BY SPINNING

Experimental research on spin-forming of cup-shaped thin-walled trapezoidal inner-gear

Experimental Research and Numerical Simulation on Cup-Shaped Thin-Walled Trapezoidal Inner Gear Formed by Spinning

Influence of gear parameters on spin-forming of cup-shaped thin-wall inner gear

Three Dimensional Numerical Simulation of Cup-Shaped Thin-Walled Inner Gear Spin-Forming

Numerical simulation and experimental study on multi-pass stagger spinning of internally toothed gear using plate blank

Analysis Of The Forming Defects Of The Trapezoidal Inner-Gear Spinning

Analysis on forming characteristics of cup-shaped thin-walled inner gear spinning

Spin-Forming Mechanism of Cup-Shaped Thin-Walled Trapezoidal Inner Gear

Effect of Spinning Process Parameters on the Forming Quality of Inner and Outer Teeth Shaped Parts

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Advances in Spinning of Aluminum Alloy Large-sized Thin-walled and Special-curved Surface Head

A new method for preform dimension and influence of relevant parameters in the gear forced throughfeed rolling process

Influence of Preformed Blank on Spin-Forming of Cup-Shaped Thin-Walled Trapezoidal Inner Gear

Cup-shape Blank Design of Inner-Gear Spinning

Application and Prospect of Spinning Technology on Inner Gear

Manufacture of Cup-shaped Thin-wailed Trapezoidal Inner Gear Spun Workpiece and Research of Metallographic Organization

Size effects on process performance and product quality in progressive microforming of shafted gears revealed by experiment and numerical modeling

Influencing Factors of Effective Tooth Depth in the Cylindrical Gear Rolling Process with Axial Infeed

A Precision Sizing Method for Cold Extruded Sun Gear with Internal-External Tooth Shapes