Abstract:Sintered gears manufactured through powder metallurgy technology contain residual porosity that can make them inadequate for high power supply. Crack propagation is significantly enhanced by both residual porosity and cyclical stresses involving the teeth. The use of densification processes can highly improve their performances, permitting the reduction of the residual porosity. Among the densification processes, the rolling assumes a key-role. The process permits the densification of the tooth flanks, the most stressed parts of the wheel. However, the performances of the rolled wheel depend on several process parameters, whose setup phase requires several efforts and many experiments. Finite element (FE) model can be a helpful tool, allowing a faster estimation of the process parameters, reducing waste and costs linked to the experimental tests. In this sense, FE modelling techniques discussed in literature only cover the simulation of spur gears densification process, since they consist of in-plane 2D finite elements. In this paper, different numerical modelling techniques, based on 2D finite elements, are proposed to simulate the densification process of spur gears and used to perform a tendency analysis to explore the effects of wheelbase reduction between the forming rollers on the material densification. Material densification appeared higher for reduced wheelbases, but an increasing cavity was observed at the tooth root as the wheelbases decreases. Moreover, a FE model based on 3D finite elements is proposed to reproduce numerically the rolling process of a helical gear. The accuracy of the 3D FE model was measured against the results provided by some experimental tests, herein discussed too. A good agreement between numerical and experimental results was observed.

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

NUMERICAL SIMULATION AND EXPERIMENTATION CUP-SHAPED THIN-WALLED INNER RECTANGULAR GEAR FORMED BY SPINNING

Numerical simulation and experimental study on multi-pass stagger spinning of internally toothed gear using plate blank

Influence of Inner Roller Geometric Parameters on Counter-Roller Spinning with 6061 Aluminum Alloy Tube

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

A new method of rolling finishing forming process of spiral bevel gears investigated by numerical simulation and experiment

Influence of the rotational speed ratio of rollers on the three-dimensional surface rolling process

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Modelling approaches for surface densification process of sintered gear teeth

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Numerical Analysis of Motorbike Profile Modified Gear Forming and Optimization of Its Mould Structure

Study on Counter-Roller Spinning Technology of Large Diameter Aluminum Alloy Cylindrical Parts

Numerical Simulation for Forging Process of Bearing Rings

Parametric Study of Meshing Characteristics With Respect to Different Meshing Rollers of the Antibacklash Double-Roller Enveloping Worm Gear

Finite element modeling of counter-roller spinning for large-sized aluminum alloy cylindrical parts

Application and Prospect of Spinning Technology on Inner Gear

The Numerical Simulation of Wheel Rim Roll Forming

Size effects on process performance and product quality in progressive microforming of shafted gears revealed by experiment and numerical modeling

The Design and Simulation of Roller for Machining Involute Spline

Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders