Abstract:The Ti-6Al-4V (TC4) alloy wheel hub has exhibited some defects that affect the properties during the vertical centrifugal casting process. Therefore, the analysis of the solidification process would contribute to solving the above-mentioned problems. In this study, an orthogonal experimental design was employed to optimize the process parameters (rotational speed, mold preheating temperature, and pouring temperature) of the vertical centrifugal casting method. The effects of process parameters on the velocity field, temperature field, and total shrinkage porosity during the solidification process were explored, and the microstructure and mechanical properties of the wheel hub prepared by the vertical centrifugal casting method were also investigated. The results showed that the rotational speed mainly induced the change of the velocity field. The pouring temperature and mold preheating temperature affected the temperature field and solidification time. Based on the analysis of the orthogonal experiment, the optimal parameters were confirmed as a rotational speed of 225 rpm, mold preheating temperature of 400 °C, and pouring temperature of 1750 °C, respectively. The simulation results of total shrinkage porosity were in agreement with the experiment results. The wheel hub was composed of nonuniform α and β phases. The lath α phase precipitated from larger β grains with different orientations. Compared with the other samples at different locations, the α phase in the PM sample (middle of the TC4 wheel hub) displayed high peak intensity and uniformly distributed β phase along the radial direction of the wheel hub. Moreover, the PM sample revealed a higher tensile strength of 820 MPa and similar Vickers hardness of 318 HV compared with the other samples at different locations, which were higher than those of rolling and extrusion molding. This experiment design would provide a good reference for the vertical centrifugal casting of the TC4 alloy.

Numerical simulation of spinning forming of A356 aluminum alloy hub using dual spinning rollers

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Study on the Design Method of Equal Strength Rim Based on Stress and Fatigue Analysis Using Finite Element Method

The Numerical Simulation about Cold Extrusion of Automotive Wheel Hub Bearing Rings

Analysis and modelling of a rotary forming process for cast aluminum alloy A356

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

On optimization of Spin-Forming Process Parameters for Magnesium Alloy Wheel Hub Based on Gray Relational Analysis

Study on Counter-Roller Spinning Technology of Large Diameter Aluminum Alloy Cylindrical Parts

Computer-Aided Designs Of Die And Thermal Control For Fabrication Of A356 Wheels

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Finite Element Simulation and Microstructural Analysis of Roll Forming for DP590 High-Strength Dual-Phase Steel Wheel Rims

Mechanical Properties and Microstructure of A356-T6 Aluminum Alloy Wheel Hub Based on Casting-Spinning Process

Spinning deformation mechanism of aluminum alloy cylinder with multi-level stiffeners based on numerical simulation

A cast spinning process for aluminum alloy wheel hub

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Numerical Simulation on Solidification during Vertical Centrifugal Casting Process for TC4 Alloy Wheel Hub with Enhanced Mechanical Properties

3D FE modeling simulation of the double-roll hot rotary forging of large diameter thin-walled metal disk

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

Finite element simulation and experiment verification of rolling forming for the truck wheel rim