Abstract:In-depth understanding and quantification of the forming characteristics of the taper-rolling process are crucial for process design and parameters determination in order for producing a desired precise helical blade from a metal strip. To this end, a quantitative study is carried out on this process through finite element (FE) simulation and experiment. For the FE simulation, a 3D model is established by handling problems observed in experiments about strip bite, sideways movement, and interference with the rolls and then is calibrated in numerically dynamic effect and validated by experiment. The results show that the plastic hoop and thickness strain components exhibit linearly increasing distributions from the inner to outer rim of the blade, which is a result of the hyperbolic-curve distributed roll gap. Thus, small radial strain that coordinates the deformation in hoop and thickness directions varies from positive to negative across the blade width. As a result, less spread and smaller bending radius have been achieved on the blade than that on the in-plane bent ring under the same conditions. Screw diameter increases with increasing initial position of the strip (H), initial roll gap (S1) and rolls offset (S2), and screw pitch increases with increasing S1 and S2 but is uncertain with increasing H, the rules of which are quantified. The reason is attributed to the change of roll gap and thus the change of strain distribution with varying H, S1, and S2. Then, three forming defects (turning-I, turning-II, and wrinkling) are defined and correspondingly the stable condition is determined as 0.9 <= az/b0 <= 1.6 and t1/t0 ≥ 0.3. Thus, a formable window of H, S1, and S2 for sound formation is determined, within which the forming limit defined as the achievable minimum relative bending radius Rin/b0 is quantified by simulation and validated by experiment.

Influence of the rotational speed ratio of rollers on the three-dimensional surface rolling process

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

The flexible rolling process of three-dimensional curved parts using an auxiliary plate based on rigid arc-shaped rollers

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

Shape prediction in continuous roll forming of sheet metal based on rigid rolls

The Design and Simulation of Roller for Machining Involute Spline

Shape Analysis of Three-Dimensional Curve Surface for Flexible Rolling Metal Plate

Numerical and experimental study of the taper-rolling process for producing a helical blade from a metal strip

Effect of multi-point roller dies on the forming accuracy of profile in flexible 3D stretch bending technology

Effect of discrete roller dies on the contour accuracy of profiles in multi-point flexible stretch-bending forming

Straightening of the rollers of planetary roller screw — Design of straightening die and experimental validation

A novel lapping method for ultraprecision cylindrical rollers based on precision evolution

Research on the Mechanism and Processability of Roll Forming

Study on multi-roller flow forming process of aluminum alloy cylinders with cross ribs

Study on the shape prediction of doubly curved shallow shell in flexible rolling process

A new method of rolling finishing forming process of spiral bevel gears investigated by numerical simulation and experiment

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Spinning of curvilinear generatrix parts without mandrel based on main and auxiliary rollers

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk