Abstract:This work reports a new simulated inductor which is suitable for a Contactless Electrical Tomography (CET) system and can effectively overcome the unfavorable influence of coupling capacitance on the measurement results. By detailed analysis and comparison, it is found that the grounded simulated inductor has a simple circuit construction but its output current is not equal to its input current, while the floating simulated inductor can be used as an independent inductor module but its circuit structure is relatively complex. A new simulated inductor is designed by compensating the currents from the common node of an introduced independent power source to the main circuit. The new simulated inductor combines the advantages of the grounded simulated inductor and the floating simulated inductor. It has the simple construction similar to that of the grounded simulated inductor and its input current is equal to the output current, which means it can be used as an independent module. The impedance measurement and practical image reconstruction experiments were carried out to verify the effectiveness of the new simulated inductor. The experimental results show that the design of the new simulated inductor is successful, and the performance of the impedance measurement is satisfactory. The signal-to-noise ratio of the CET system is improved. Meanwhile, the research work also indicates that in the case when the independent power source is not available, the new simulated inductor is also an effective alternative method. But the phase difference between input signal and output signal is approximately 90° when the elimination principle is realized.

Analysis and Optimum Design of Differential Inductors Using Distributed Capacitance Model

Analysis of Self-Resonant Frequency for Differential-Driven Symmetric and Single-Ended Inductors

Parasitic Inductance Modeling for On-chip Interconnects Based on IC Analysis on Inductive Effects

A Scalable Model of On-chip Inductor Including Tunable Dummy Metal Density Factor

A Physics-Aware Methodology for Equivalent Circuit Model Extraction of TSV-inductors

On the Design of a New Simulated Inductor Using a Contactless Electrical Tomography System As an Example

A Compact Circuit Model of On-Chip Multi-layer Spiral Inductors on Silicon Substrate

A derived circuit model for spiral inductors on lossy silicon substrate

Analysis of Frequency- and Temperature-Dependent Substrate Eddy Currents in On-Chip Spiral Inductors Using the Complex Image Method

Modelling On-Chip Circular Double-Spiral Stacked Inductors for RFICs

Modeling of TSV-based Solenoid Inductors for 3-D Integration

Asic Design of an Integrable Simulated Inductor with Huge Inductance

Rethinking Basic Assumptions for Modeling Parasitic Capacitance in Inductors

An Improved Foster Model of Common-Mode Inductor and Its Application in EMI Filter Design

Equivalent Model and Parameter Extraction of Center-Tapped Differential Inductors

Equivalent Inductance Analysis and Quantification for PCB PDN Design

Complex Circuit Model for RF Inductors

The Magnetized Capacitance, First Resonant Frequency, and Electromagnetic Analysis of Inductors With Ferrite Cores

Development of an Inductor Design Tool Based on Multi-Objective Optimization and Finite Element Simulation

Energy Transfer Modes of the Quasi-Z-Source DC-DC Converter Considering Critical Inductance

Modeling and Parameter Sensitivity Analysis of Inductor Used Multi-material Powder Core