Abstract:Using the complex image method (CIM), we have analyzed the frequency and temperature dependencies of substrate eddy currents for single-ended and differential spiral inductors on a lossy silicon substrate. From our analysis, we have derived a set of accurate closed-form expressions for calculating inductances and substrate losses due to substrate eddy currents. Here, we propose a frequency-dependent eleven-element equivalent circuit model based on these formulas. We established the validity of the model by comparing the simulated and measured results, which are in good agreement. Index Terms—Complex image method (CIM), differential inductor, eddy currents, greenhouse algorithm, inductor model. HE high operating frequencies, at which deep submicrom- eter and nano-scale CMOS devices are able to operate, have brought radio-frequency integrated circuits (RFICs) in the realm of CMOS making the quality factor of the on-chip spiral inductors a focus of intense research. The quality factor of the on-chip inductor is limited by the losses due to the finite conduc- tivity of the metal and the conducting silicon substrate. Non-per- fect metal wires used to form spiral inductors cause ohmic loss due to the non-zero resistance at low frequencies. Additionally the non-uniform current distribution in metal wires at high fre- quencies increases the losses and degrades the quality factor of inductors. This loss mechanism has been extensively studied as skin- and proximity-effect (1)-(12).

Complex Circuit Model for RF Inductors

Quasi-Static Derived Physically Expressive Circuit Model for Lossy Integrated RF Passives

A derived circuit model for spiral inductors on lossy silicon substrate

A Compact Circuit Model of On-Chip Multi-layer Spiral Inductors on Silicon Substrate

Analysis of Frequency- and Temperature-Dependent Substrate Eddy Currents in On-Chip Spiral Inductors Using the Complex Image Method

Compact Equivalent Circuit Model Of Two-Layer Spiral Inductors

A Physics-Aware Methodology for Equivalent Circuit Model Extraction of TSV-inductors

A Derived Physically Expressive Circuit Model For Integrated Passives In Rfic

A Lumped Common Mode Choke Model By Finite Element Software Considering Complex Permeability Change With Frequency

Modeling of On-Chip Rf Passive Components

Accurate Model for Micromachined Microwave Planar Spiral Inductors

Calculation of RF-MEMS Inductors Using Partial Element Equivalent Circuits

Microwave Modeling and Parameter Extraction Method for Multilayer On-Chip Inductors

EMI Noise Analysis for a High-Frequency Power Inductor Model Based PFC Converters

Compact Fractional-Order Model of On-Chip Inductors with BCB on High Resistivity Silicon

Modeling of Parasitic Inductive Couplings in a Pi-Shaped Common Mode EMI Filter

High Frequency Modeling for Common Mode Chokes Based on Impedance Measurement

Research on Full-Circuit Model of Common-Mode Choke

Simulation and Design of the RF MEM Inductors and LC Low-Pass Filters

Design Optimization and Modeling of On-Chip RF Inductors in 0.13&#x00b5;m and 90nm Standard CMOS

RF CMOS is More Than CMOS: Modeling of RF Passive Components