Abstract:Global carbon dioxide emissions are rising and the use of fossil fuels in several sectors are the leading causes. As global population and economies continue to grow significantly, the most practical method of lowering such emissions is to capture CO2. Although other technologies are more developed, adsorption is very promising and has attracted much attention. To ensure this technology's success, it is essential to have suitable CO2 adsorbent materials. In this work, several new hydrotalcites (HTs) with different initial concentrations of ion precursors were prepared for the first time by the co-precipitation method—it was possible to verify that the ion concentrations influence the characteristics of the materials. The prepared HTs were characterized by thermogravimetric analysis (TG), X-Ray diffraction (XRD), surface area measurements and temperature-programmed desorption of CO2 (TPD-CO2) to relate their CO2 capture capacity to their physicochemical properties; the CO2 adsorption equilibrium isotherms were determined at 35 and 300 °C for the prepared samples, as well as for some commercial materials: magnesium oxide, calcium oxide, aluminium oxide and Zeolite 13X. After determining which materials present the best CO2 adsorption capacity, these were submitted to adsorption-desorption cycles to study their stability. The main objective of the work was to prepare and study different CO2 adsorbents for processes that are carried out at low and intermediate temperatures. From the experimental results, it was possible to conclude that the Zeolite 13X showed the best capacity at 35 °C, 3.38 mmol·g−1 (@= 1 bar), and a prepared calcined HT (c-HT2) was the best at 300 °C, 0.97 mmol·g−1 (@= 1 bar). Moreover, it seems there is an optimum initial concentration of the ions' solutions for the tested HTs, which depends on the final application—c‐HT1 showed a better capacity at 35 °C and c‐HT2 at 300 °C. From the adsorption‐desorption cycles—performed at 35 and 300 °C with the best materials using a magnetic suspension microbalance at 1 bar of CO2 partial pressure —, a working cyclic capacity of 2.69 mmol∙g−1 was achieved by the Zeolite at 35 °C; in turn, c-HT2 showed a working cyclic capacity of 0.79 mmol∙g−1 at 300 °C.

Impact of Heating Rate on Desorption Performance of CO2 Attached to 13X Zeolite

Factors of CO2 Adsorption Ratio of CO2 Sorbent Used in the Adsorption Enhanced Reaction to Producing Hydrogen from Nature Gas

Performance Exploration of Temperature Swing Adsorption Technology for Carbon Dioxide Capture

Effect of Heating-Rate on Ca-based Absorbent Performance of CO2 Capture

High-pressure Carbon Dioxide Adsorption Kinetics of Potassium-Modified Hydrotalcite at Elevated Temperature

Preparation and Characterization of Materials for Low- to Intermediate-Temperature CO2 Adsorption

PRELIMINARY STUDY ON PERFORMANCE OF Zn-DOPED ZEOLITE IN LOW-TEMPERATURE CO2 ADSORPTION

A Kinetic Study of Microwave‐Assisted Desorption of Co2 from Zeolite 13x

Enhanced Tolerance to Flue Gas Contaminants on Carbon Dioxide Capture Using Amine-Functionalized Multiwalled Carbon Nanotubes

Thermodynamics and Regeneration Studies of CO2 Adsorption on Activated Carbon

Temperature Programmed Desorption - an Application to Kinetic Studies of Co Desorption at Electrochemical Interfaces

A Combined Gcmc And Fvm Simulation Method For Co2 Adsorption In 13x Zeolite Adsorption Bed

Impact of H2O on CO2 adsorption and co-adsorption: Mechanism and high-performance adsorbents for efficient H2O-CO2 capture

Temperature Effects on CO Adsorption/desorption at Pt Film Electrodes: an Electrochemical in Situ Infrared Spectroscopic Study.

High-temperature CO 2 adsorption on Li XZr YO Z ceramics

CO2 Residual Concentration of Potassium-Promoted Hydrotalcite for Deep CO/CO2 Purification in H2-rich Gas

Adsorption and Desorption Experimental Study of Carbon Dioxide/Methane Mixture Gas on 13X-Type Molecular Sieves

Temperature-Programmed Desorption of Pyridine on Zeolites in the Presence of Liquid Solvents

Temperature Programmed Desorption and Thermal-Decomposition of N-Butylamine on Zeolite Hzsm-5

Improvement of Temperature Profiles Using Variable Heat of Adsorption in Modeling H 2 /CO 2 Breakthrough Experiments

Adsorption behaviour of molecular sieve and activated carbon for CO2 adsorption at cold temperatures