Abstract:In this paper, aluminium chloride crystal was used as precursor to prepare silica-alumina aerogel support by sol gel method, and the active component K2CO3 was supported on the aerogel support by incipient-wetness impregnation method to obtain a modified potassium-based adsorbent. CO2 adsorption experiment was performed on the adsorbent under different reaction conditions using a small fixed-bed reactor self designed. Based on the characterization results of low temperature N-2 adsorption-desorption experiments and scanning electron microscopy, CO2 adsorption characteristics of modified potassium-based adsorbents were studied. The prepared silica-alumina aerogel support has good microstructure and uniform pores with specific surface area and pore volume are 445.7517 m(2)/g and 2.3270 cm(3)/g, respectively, and the mesopores account for more than 99%. After loading, the active component K2CO3 is uniformly dispersed. Through model comparison, it was determined that the shrinking core model and Avrami fractional kinetic model were used to fit the experimental results in order to study the reaction kinetics and adsorption kinetics. The results show that as the temperature rises, the amount of CO2 adsorbed by the adsorbent increases first and then decreases. The increase in temperature can improve the activity of the active site of the adsorbent and make the reversible exothermic reaction occur while the adsorbent adsorbs CO2 cannot proceed in the forward direction at the same time. According to the kinetic analysis, the control period of the surface chemical reaction is too short due to the high temperature, which caused low carbonation conversion. The optimal designed loading of modified potassium-based adsorbent, reaction temperature, water vapor pretreatment time, CO2 concentration and total gas volume were 30%, 60 degrees C, 30 min, 12.5%, and 500 mL/min, respectively.

Factors of CO2 Adsorption Ratio of CO2 Sorbent Used in the Adsorption Enhanced Reaction to Producing Hydrogen from Nature Gas

The Characteristics of A Sorption-Enhanced Steam-Methane Reaction for the Production of Hydrogen Using Co2 Sorbent

Properties of a Nano CaO/Al2O3 CO2 Sorbent

Adsorption Properties of Coating Modified Nano CaO-Based CO2 Adsorbents

Properties of a Nano CaO/Al<sub>2</sub>O<sub>3</sub>CO<sub>2</sub>Sorbent

Regenerable MgO-based Sorbents for CO2 Capture at Elevated Temperature and Pressure: Experimental and DFT Study

Effects of CO and CO2 on the Removal of Elemental Mercury over Carbonaceous Surfaces

CO2 Residual Concentration of Potassium-Promoted Hydrotalcite for Deep CO/CO2 Purification in H2-rich Gas

Layered Double Oxide/activated Carbon-Based Composite Adsorbent for Elevated Temperature H 2 /CO 2 Separation

Effect of operating parameters for CO 2 capture from syngas of supercritical water gasification using K 2 CO 3 /γ-Al 2 O 3 composite adsorbent

Effect of operating parameters for CO2 capture from syngas of supercritical water gasification using K2CO3/γ-Al2O3 composite adsorbent

Adsorption and Desorption Experimental Study of Carbon Dioxide/Methane Mixture Gas on 13X-Type Molecular Sieves

Enhancement of CO2 Adsorption Performance on Hydrotalcites Impregnated with Alkali Metal Nitrate Salts and Carbonate Salts

Hydrogen Rich Fuel Gas Production by Gasification of Wet Biomass Using A Co2 Sorbent

Experiment and Kinetic Model Study on Modified Potassium-Based CO2 Adsorbent

Experimental Study on the Kinetics of CO2 and H2O Adsorption on Honeycomb Carbon Monoliths under Cement Flue Gas Conditions

High-temperature CO 2 adsorption on Li XZr YO Z ceramics

Carbon Dioxide Adsorption over Activated Carbons Produced from Molasses Using H2SO4, H3PO4, HCl, NaOH, and KOH as Activating Agents

A surfactant modified solid amine adsorbent to enhance CO 2 adsorption performance

Hydrogen-rich syngas upgrading via CO2 adsorption by amine-functionalized Cu-BTC: the effect of different amines

Study on CO2 Capture Performance by Potassium-Promoted MgAl-Hydrotalcite Adsorbent