Abstract:Global carbon dioxide emissions are rising and the use of fossil fuels in several sectors are the leading causes. As global population and economies continue to grow significantly, the most practical method of lowering such emissions is to capture CO2. Although other technologies are more developed, adsorption is very promising and has attracted much attention. To ensure this technology's success, it is essential to have suitable CO2 adsorbent materials. In this work, several new hydrotalcites (HTs) with different initial concentrations of ion precursors were prepared for the first time by the co-precipitation method—it was possible to verify that the ion concentrations influence the characteristics of the materials. The prepared HTs were characterized by thermogravimetric analysis (TG), X-Ray diffraction (XRD), surface area measurements and temperature-programmed desorption of CO2 (TPD-CO2) to relate their CO2 capture capacity to their physicochemical properties; the CO2 adsorption equilibrium isotherms were determined at 35 and 300 °C for the prepared samples, as well as for some commercial materials: magnesium oxide, calcium oxide, aluminium oxide and Zeolite 13X. After determining which materials present the best CO2 adsorption capacity, these were submitted to adsorption-desorption cycles to study their stability. The main objective of the work was to prepare and study different CO2 adsorbents for processes that are carried out at low and intermediate temperatures. From the experimental results, it was possible to conclude that the Zeolite 13X showed the best capacity at 35 °C, 3.38 mmol·g−1 (@= 1 bar), and a prepared calcined HT (c-HT2) was the best at 300 °C, 0.97 mmol·g−1 (@= 1 bar). Moreover, it seems there is an optimum initial concentration of the ions' solutions for the tested HTs, which depends on the final application—c‐HT1 showed a better capacity at 35 °C and c‐HT2 at 300 °C. From the adsorption‐desorption cycles—performed at 35 and 300 °C with the best materials using a magnetic suspension microbalance at 1 bar of CO2 partial pressure —, a working cyclic capacity of 2.69 mmol∙g−1 was achieved by the Zeolite at 35 °C; in turn, c-HT2 showed a working cyclic capacity of 0.79 mmol∙g−1 at 300 °C.

CO2 Residual Concentration of Potassium-Promoted Hydrotalcite for Deep CO/CO2 Purification in H2-rich Gas

Factors of CO2 Adsorption Ratio of CO2 Sorbent Used in the Adsorption Enhanced Reaction to Producing Hydrogen from Nature Gas

Ca based high temperature CO2 absorbents for sorption enhanced reforming process

Layered Double Oxide/activated Carbon-Based Composite Adsorbent for Elevated Temperature H 2 /CO 2 Separation

Elevated Temperature Pressure Swing Adsorption Process for Reactive Separation of CO/CO2 in H2-rich Gas

Elevated Pressure CO2 Adsorption Characteristics of K-promoted Hydrotalcites for Pre-combustion Carbon Capture

High-pressure Carbon Dioxide Adsorption Kinetics of Potassium-Modified Hydrotalcite at Elevated Temperature

K‐Promoted Hydrotalcites for CO2 Capture in Sorption Enhanced Reactions

Effects of CO and CO2 on the Removal of Elemental Mercury over Carbonaceous Surfaces

Hydrophobic activated carbon for elevated-temperature pressure swing adsorption

Experimental investigation on a new method for CO deep purification in coal-derived syngas

Study on CO2 Capture Performance by Potassium-Promoted MgAl-Hydrotalcite Adsorbent

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Experimental Characterization and Mechanistic Simulation of CO2 Adsorption/Desorption Processes for Potassium Promoted Hydrotalcites Sorbent

Recent Advances in the Research of High-temperature CO2 Adsorbents and Absorbents

High-temperature CO 2 adsorption on Li XZr YO Z ceramics

System And Processes Of Pre-Combustion Carbon Dioxide Capture And Separation

Effective adsorption of Ultra-dilute CO2 over Polyethyleneimine-based adsorbent for H2 purification

Preparation and Characterization of Materials for Low- to Intermediate-Temperature CO2 Adsorption

CO 2 capture using low silica X zeolite synthesized from low-grade coal gangue via a two-step activation method

Enhancement of CO2 Adsorption Performance on Hydrotalcites Impregnated with Alkali Metal Nitrate Salts and Carbonate Salts