Abstract:Elevated-temperature pressure swing adsorption is a promising technique for producing high purity hydrogen and controlling greenhouse gas emissions. Thermodynamic analysis indicated that the CO in H-2 rich gas could be controlled to trace levels of below 10 ppm by in situ reduction of the CO2 concentration to less than 100 ppm via the aforementioned process. The CO2 adsorption capacity of potassium-promoted hydrotalcite at elevated temperatures under different adsorption (mole fraction, working pressure) and desorption (flow rate, desorption time, steam effects) conditions was systematically investigated using a fixed bed reactor. It was found that the CO2 residual concentration before the breakthrough of CO2 mainly depended on the total amount of purge gas and the CO2 mole fraction in the inlet syngas. The residual CO2 concentration and uptake achieved for the inlet gas comprising CO2 (9.7 mL/min) and He (277.6 mL/min) at a working pressure of 3 MPa after 1 h of Ar purging at 300 mL/min were 12.3 ppm and 0.341 mmol/g, respectively. Steam purge could greatly improve the cyclic adsorption working capacity, but had no obvious benefit for the recovery of the residual CO2 concentration compared to purging with an inert gas. The residual CO2 concentration obtained with the adsorbent could be reduced to 3.2 ppm after 12 h of temperature swing at 450 degrees C. A new concept based on an adsorption/desorption process, comprising adsorption, steam rinse, depressurization, steam purge, pressurization, and high-temperature steam purge, was proposed for reducing the steam consumption during CO/CO2 purification. (C) 2017 Science Press and Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. and Science Press. All rights reserved.

Experimental Characterization and Mechanistic Simulation of CO2 Adsorption/Desorption Processes for Potassium Promoted Hydrotalcites Sorbent

Study on the kinetics of Ca-based CO2 sorbent of carbonation and calcination for adsorption enhanced reforming process

Elevated temperature hydrogen/carbon dioxide separation process simulation by integrating elementary reaction model of hydrotalcite adsorbent

Mechanism Modeling of Elevated Temperature Pressure Swing Adsorption Process for Pre-Combustion Co2 Capture

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Performance Exploration of Temperature Swing Adsorption Technology for Carbon Dioxide Capture

Porosity and hydrophilicity modulated quaternary ammonium-based sorbents for CO<sub>2</sub> capture

Regenerable MgO-based Sorbents for CO2 Capture at Elevated Temperature and Pressure: Experimental and DFT Study

Elevated Pressure CO2 Adsorption Characteristics of K-promoted Hydrotalcites for Pre-combustion Carbon Capture

System And Processes Of Pre-Combustion Carbon Dioxide Capture And Separation

K‐Promoted Hydrotalcites for CO2 Capture in Sorption Enhanced Reactions

Design, characterization and scale-up test of a high performance pre-combustion CO2 adsorbent

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Performance of H2S sorption and CO2-H2S co-sorption on potassium promoted hydrotlcites

Molecular Dynamics Simulation of CO2 Uptake in NKPOC-1: Understanding the Temperature-Dependent Multistep Adsorption in Soft Porous Molecular Crystal

Simulation of CO2 capture from natural gas by cyclic pressure swing adsorption process using activated carbon

A High Adsorption Capacity Bamboo Biochar for CO2 Capture for Low Temperature Heat Utilization

Thermodynamic Exploration of Two-Stage Vacuum-Pressure Swing Adsorption for Carbon Dioxide Capture

High-pressure Carbon Dioxide Adsorption Kinetics of Potassium-Modified Hydrotalcite at Elevated Temperature

Carbon dioxide capture by functionalized solid amine sorbents with simulated flue gas conditions.

CO2 Residual Concentration of Potassium-Promoted Hydrotalcite for Deep CO/CO2 Purification in H2-rich Gas