Abstract:Purification section of syngas from coal is located after water gas shift to remove hydrogen sulfide, carbon dioxide as the main gas impurities and obtain high purity hydrogen. At present, the mature purification processes include wet method represented by low temperature methanol scrubbing and liquid nitrogen scrubbing, and dry method represented by pressure swing adsorption decarburization. The operating temperature of the elevated temperature pressure swing adsorption technology proposed is consistent with the temperature of the incoming shift gas. Self-made hydrophobic nitrogen-rich activated carbon adsorbent was deployed to achieve desulfurization and carburization by increasing the traditional pressure swing adsorption operating temperature to 170-220 ℃ and high humidity environment. Two new PSA steps, high pressure steam rinse and low pressure nitrogen purge, were adopted to improve H 2 recovery to above 99%. The elevated temperature pressure swing adsorption H 2 /CO 2 separation demonstration with a processing capacity of 5 000 m~3/h（standard condition）was built and operated using coal based shift gas from Quanji Plant as the feedstock for the pilot plant. The purity of hydrogen reaches the hydrogen fuel level（including N 2 ） through two-stage ETPSA, and the pilot plant has been running for more than 2 800 hours in total. In addition, the energy consumption of the pilot plant was calculated based on the utilities expenses. When taking power consumption into consideration, the operation cost of H 2 purification for the pilot test can be significantly reduced by about 35% compared with the power consumption of H 2 purification by low temperature methanol scrubbing at Fengxi Plant. This technology breaks through the limitation of temperature of conventional adsorption and purification for solid adsorbents, and realizes directional removal of impurities in hydrogen by using adsorbents with preferred selective adsorption performance at elevated temperature, which confirms a new process route for efficient and high-quality hydrogen purification.

Elevated temperature hydrogen/carbon dioxide separation process simulation by integrating elementary reaction model of hydrotalcite adsorbent

Mechanism Modeling of Elevated Temperature Pressure Swing Adsorption Process for Pre-Combustion Co2 Capture

Modelling and Simulation of Two-Bed PSA Process for Separating H2 from Methane Steam Reforming

Experimental Characterization and Mechanistic Simulation of CO2 Adsorption/Desorption Processes for Potassium Promoted Hydrotalcites Sorbent

Performance Exploration of Temperature Swing Adsorption Technology for Carbon Dioxide Capture

Study of Modeling for Fixed-Bed Adsorption Process and Simulation in Experimental CO Separation Through PSA

Adsorbent Characteristic Regulation and Performance Optimization for Pressure Swing Adsorption Via Temperature Elevation

Correlations Between Adsorbent Characteristics and the Performance of Pressure Swing Adsorption Separation Process

Improvement of Temperature Profiles Using Variable Heat of Adsorption in Modeling H 2 /CO 2 Breakthrough Experiments

System And Processes Of Pre-Combustion Carbon Dioxide Capture And Separation

Simulation of CO2 capture from natural gas by cyclic pressure swing adsorption process using activated carbon

Elevated Temperature Adsorbents for Separation Applications

Study and demonstration of H2/CO2 separation of syngas from coal by elevated temperature pressure swing adsorption

Heat and mass transfer during H2O/CO2 adsorption separation using activated alumina

Elevated Temperature Pressure Swing Adsorption Process for Reactive Separation of CO/CO2 in H2-rich Gas

Modeling and optimal design of multicomponent vacuum pressure swing adsorber for simultaneous separation of carbon dioxide and hydrogen from industrial waste gas

CO2 Residual Concentration of Potassium-Promoted Hydrotalcite for Deep CO/CO2 Purification in H2-rich Gas

CFD Simulation for Separation of Carbon Dioxide-Methane Mixture by Pressure Swing Adsorption

Elevated Pressure CO2 Adsorption Characteristics of K-promoted Hydrotalcites for Pre-combustion Carbon Capture

High-pressure Carbon Dioxide Adsorption Kinetics of Potassium-Modified Hydrotalcite at Elevated Temperature

Impedance Characterization of Elevated Temperature Carbon Dioxide Adsorption Process on Potassium-Modified Hydrotalcite