Abstract:Negative temperature coefficient (NTC) thermistor materials based on (LaMn 0.5 Co 0.5 O 3 ) x –(Ni 0.66 Mn 2.34 O 4 ) 1−x (0 ≤ x ≤ 0.5) composite ceramics, are fabricated by the conventional solid-state reaction method. The crystal structure, surface morphology and electrical properties of the composite ceramics are investigated and characterized by X-ray powders diffraction (XRD), scanning electron microscope (SEM), and Agilent digital multimeter, respectively. XRD results show that main phases of as-sintered ceramics are a cubic spinel structure Ni 0.66 Mn 2.34 O 4 phase and a rhombohedral perovskite structure LaMn 0.5 Co 0.5 O 3 phase. SEM images indicate that the grain size of the composite ceramics decreases with increasing the low-resistivity perovskite phase. The ρ 25 and B value of the composite ceramics decreases with increasing x, and the B is still reasonably high in the range of 4000–3500 K when x ≤ 0.2. Meanwhile, the introduction of the perovskite phase leads to a decrease in the resistance drift, which the ΔR/R 0 is relatively low (0.26–1.8 %) after annealing at 125 °C for 600 h in air atmosphere. These findings exhibit that (LaMn 0.5 Co 0.5 O 3 ) x –(Ni 0.66 Mn 2.34 O 4 ) 1−x (0 ≤ x ≤ 0.5) composite ceramics have a higher electrical stability in comparison with Ni 0.66 Mn 2.34 O 4 ceramics, are helpful for meeting demands for obtaining better stability and performance of NTC composites ceramics.

The Sintering and Electrical Properties of Zn-substituted LaCo0·4Ni0·6O3 Ceramics Based Upon Experiments and Calculations

Evaluation of Zn‐substituted La0.5Sr0.5CoO3 Ceramics As Functional Materials for Thick‐film Resistors

Experimental And Theoretical Study On The Resistive Properties Of Laco0.4ni0.6o3 Ceramic With Mg-Ion Substitution

Low temperature coefficient of resistance and high conductivity: Enhanced Cu–substituted LaCo0.4Ni0.6O3 ceramics for functional material

Experimental and theoretical study on enhanced electrical properties of nickel-substituted La<sub>0.5</sub>Sr<sub>0</sub><sub>.5</sub>Co<sub>0.</sub><sub>3-</sub> ceramics

Experimental and theoretical study on enhanced electrical properties of nickel-substituted La0.5Sr0.5CoO3−δ ceramics

Improved Nb–substituted La0.5Sr0.5CoO3 Ceramics As New and Low–cost Functional Materials for Thick–film Resistors

High–performance Copper–substituted La0.5Sr0.5CoO3 Ceramics As Economical Functional Materials for Thick Film Resistors

High-performance Electrical Properties of La-based Perovskite Ceramics for the Functional Phase of Thick Film Resistors

(Bi0.5na0.5)(zr0.97w0.01fe0.02)o3 Doping Effects on KNN‐based Lead‐free Ceramics Prepared Via Two‐step Sintering Technique

Dielectric Performance and Conductive Mechanism of KNN-based Ceramics Prepared Via Sol–gel Core–shell Process

Influence of V5+ Incorporation on the Resistive and Sintering Properties of LaCo0.4Ni0.6O3 Ceramic

Phase evolution, dielectric and conductivity behaviors of (K 0.5 Na 0.5 )NbO 3 –La(Zn 0.5 Zr 0.5 )O 3 ceramics

Preparation and characterization of LaMn 0.5 Co 0.5 O 3 –Ni 0.66 Mn 2.34 O 4 composite NTC ceramics

Effect of Ni Substitution on Electrical and Thermoelectric Properties of LaCoO3 Ceramics

The Sintering and Electrical Properties of La0.5Sr0.5Co0.96Ni0.04O3-δ Ceramics with B2O3- CuO Addition

Crystal structure, Raman spectra, and modified dielectric properties of pure-phase ZnZrNb<sub>2</sub>O<sub>8</sub> ceramics at low temperature

The effect of Cu substitution on microstructure and thermoelectric properties of LaCoO3 ceramics.

Effect of V Substitution on the Electrical Properties of La 0.5 Sr 0.5 Co 1− X V X O 3 ( X = 0.00–0.10) Ceramics

Effect of Zn2+ substitution on sintering behavior and dielectric properties of NdNbO4 ceramics

The Investigation of Zn Content on the Structure and Electrical Properties of Zn X Cu0.2Ni0.66Mn2.14−x O4 Negative Temperature Coefficient Ceramics